Publicidad
Idiomas disponibles
Idiomas disponibles
Figure 4
Figure 5
Figure 6
PAGE 3 OF 9
STEEL TOP ASSEMBLY
BASE TABLE
Hardware pack includes:
1. Align leg holes to end of tabletop. Secure with six
1/4"-20 x 5/8" bolts. Threaded inserts are provided on
each tabletop end. (See Figure 4)
2. Set bench assembly upright and recheck all bolts
for tightness.
L-EXTENSION
1. Align leg holes to end of tabletop. Secure leg (2)
with eight 1/4"-20 x 5/8" bolts. Threaded inserts are
provided. (See Figure 4)
2. Secure L-leg (6) with four 1/4"-20 x 5/8" bolts.
Threaded inserts are provided. (See Figure 5)
3. Set bench assembly upright and recheck all nuts,
bolts and screws for tightness.
L-TABLE
1.
With both table assemblies upright, slide L-extension
underneath base table on right or left hand side.
Make sure that table corners align and that the six
bolt locations closest to the center of the leg align
with the holes on the edge of the base tabletop.
(See Figure 6)
2. Attach L-leg (6) to underside of 72" top (5) with six
nuts, bolts and lock washers.
1-800-295-5510
uline.com
DESCRIPTION
1/4"-20 x 5/8" Bolts
1/4"-20 Nuts
Lock Washers
NOTE: There are four mounting channels
provided for installing an optional cabinet or
drawer.
NOTE: Do not lean on table. You may need to
prop up corner without leg until table is fully
assembled.
QTY
30
18
18
0221 IH-8404
Publicidad
