Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
NOTE
After normal use, the battery pack will require 70 min of charging before it will be
fully charged. A completely discharged battery will require more than 70 minutes in
order to be fully charged.
Disconnect charger from power source when not in use.
The battery pack was discharged after its manufacture. Therefore, it will require 5-
10 charges / discharges before it reaches full capacity.
INSTALLING AND REMOVING THE HANGER RING
1. To install or place the hanger ring through the tool hanger.
2. Position the tool hanger on the tool over the two screw holes.
3. Insert the two screws. Hand tighten the screws with screwdriver.
4. To remove the hanger and hanger ring, reverse the procedure.
WARNING
− Do not hang tools on high places or unstable surfaces.
− When hanging the tool on the hanger ring, hang it carefully. Otherwise the tool may
fall and cause injury.
INSTALLING THE SIDE HANDLE
1.
To install the side handle, loosen the side handle knob unit the ring loosens.
2.
Slide the ring over the front of the tool until the detents are resting in the groove.
3.
Tighten the side handle knob until it is secure.
4.
To adjust the side handle, loosen the knob and rotate to the desired position. Then
1English1
ASSEMBLY
Hanger Ring
English
Fig. 1
-10
Publicidad
Tabla de contenido
