Air Curtain Activation; Orientation Of The Air Flaps - emmeti ACI Serie Manual De Instalacion Y Uso

2. INSTALLATION

2.4 Air curtain activation

After completing installation and electrical connection, the air jet can be
turned on using the remote control.
1 Point the remote control at the air jet and press the ON/OFF button.
The presence of electrical energy will be signalled by the LED on the
control panel, and the fan will start turning.
2 Using the two FAN SPEED buttons on the remote control, you can
increase or decrease fan speed.
Range of fan speed control: from 1 to 15.
3 To turn off, point the remote control at the air jet and press the ON/
OFF button. The fan will stop immediately.
Attention!
If there is a power outage during operation of the air jet, it will shut
down immediately. As soon as the electricity comes back on, it will
resume operation at the same speed.
2.5 Orientation of the air flaps
The air jet is provided with two deflectors. Their angle determines the
maximum functionality of the air jet, figure A. Figures B, C and D show the
proper orientation depending on the season and the position of the unit.
The inclination can be adjusted manually as shown in figure A.
Warning!
Do not incline the flap too much, this could hinder the desired "air barrier"
effect. In order to easily adjust the flaps, it is recommended to apply paper
bands on the delivery opening and to turn on the device.
The angle that will be formed will be useful for making the adjustment.
-15
Fig. A
+15
2.5.1 Air curtain mounted inside the room
External space
(dirty air, bad
odours insects)
Fig. B
2.5.2 Air curtain mounted inside of an air conditioned room
(summer period)
External space hot
Fig. C
2.5.3 Air curtain mounted inside an air conditioned room
(winter period)
External space cold
Fig. D
GB GB
Internal space
(clean air)
Internal space cooled
Internal space heated
21