Care And Maintenance Instructions; Cleaning The Lint Filter; Cleaning The Control Panel - Asko T701 Guía De Uso Y Cuidado

CARE AND MAINTENANCE INSTRUCTIONS

CLEANING THE LINT FILTER

The wear on fabrics in a tumble dryer is insignificant. The
lint caught in the lint filter is dust and fiber residue that has
been formed when the garments have been worn. The lint
filter must be cleaned after each load. If this is not done,
drying performance will suffer, as insufficient air will pass
through the drum. The machine may also overheat after
a while, which will cause it to stop automatically.
To clean the lint filter, follow the steps below:
1. Grasp the handle and pull it toward you.
2. Remove the filter from the holder.
3. Open the filter and
gently brush away any
lint.
4. Fold the filter together
and return it to the
holder on the door.
5. Push the holder in
until it snaps into
place.
CLEANING
THE
CONTROL PANEL
To clean the control panel, use only a soft, warm, damp
(not wet) cloth. To prevent penetration of water into
the door lock and electrical components, never spray
water or cleaning solvent of any kind on the control
panel.
Also, never use abrasive cleaners or scouring pads on
the outer surfaces because they will scratch the finish and
possibly remove the writing on the control panels. Some
paper towels may also scratch the finish.
Page 18
All manuals and user guides at all-guides.com
EMPTYING THE CONDENSED
WATER CONTAINER (T721 AND
T781 ONLY)
If the dryer is not installed to pump out the condensed
water into a drain or sink, the condensation water collects
in the water container to the left of the control panel.
You should empty the container every three to five dryer
loads, depending on the spin speed you use when you
wash the clothes. For example, clothes spun at 800 rpm
will have more moisture when you take them out of the
washer than clothes spun at 1400 rpm. Therefore, the
dryer will have to remove more water.
To empty the container, follow the steps below:
1. Pull out the container.
2. Pour out the water.
3. Replace the container. You
should hear it snap into
place.
NOTE: Do not remove the water container while the
machine is running.
The condensed water is soft and safe to use for watering
plants.
If the container becomes too full, the machine with shut
down. To restart the program, empty the container and
press Start. It may be a few minutes before the machine
starts because it drains the excess water from the sump
before it restarts.
CLEANING THE EXHAUST HOSE
About once a year you should remove the exhaust hose
and clean it. At this time, you should also clean the
exhaust outlet on the machine and the ventilation duct.
Periodically, you should check the dryer exhaust outside
to be sure the air flow is strong and nothing is blocking
the vent.