Samsung DW60M5060BB Manual Del Usuario página 46

Installation instruction
Step 4. Tension adjustment of the door spring
After placed the panel on the dishwasher, please try open and close the door to test the balance to check
out whether the door can remain a same place. If not, please adjusting the screw in the direction of
clockwise or counter-clockwise to adjust the balance of the door. Or it has been adjusted.
Step 5. Connecting the water inlet hose (for cold water)
After placed the panel on the dishwasher, please try open and close the door to test the balance to check
out whether the door can remain a same place. If not, please adjusting the screw in the direction of
clockwise or counter-clockwise to adjust the balance of the door. Or it has been adjusted.
Connection the cold water supply hose to a threaded 3/4(inch) connector
and make sure that it is fastened tightly in place.
If the water hoses are new or have not been used for an extended period
of time, let the water run to make sure that the water is clear and free of
impurities, If this precaution is not taken, there is a risk that the water inlet
can get blocked and the appliance could be damaged.
Step 5-1. Electrical connection
Make sure the socket is compatible with the plug of the appliance, The
socket must have ground wire and can hold 250V/10A, otherwise damage
or accidence may occur,Other electric appliance with big power
can not use the same socket with the dishwasher.
46_ Installation Instruction
DW4000KM-00000A-00_EN (Basic)_160323.indd
+
-
Hexnut tools
CR-V 4mm
3~8 KG
36
30°~90°balance