Connecting A Vcr; Video Connection; Connecting An Amplifier / Dvd Home Theater - Samsung 4 Serie Manual Del Usuario

Connecting a VCR

Video Connection

❑
These instructions assume that you have already connected your TV to an antenna or a cable TV system (according to the
instructions on pages 9~10). Skip step 1 if you have not yet connected to an antenna or a cable system.
1. Unplug the cable or antenna from the back of the TV.
. Connect the cable or antenna to the ANT IN terminal on the back of the VCR.
. Connect an Antenna Cable between the ANT OUT terminal on the VCR and the ANT IN terminal on the TV.
4. Connect a Video Cable between the AV IN 1 [Y/VIDEO] jack on the TV and the VIDEO OUT jack on the VCR.
5. Connect Audio Cables between the AV IN 1 [R-AUDIO-L] jacks on the TV and the AUDIO OUT jacks on the VCR.
VCR Rear Panel

If you have a "mono" (non-stereo) VCR, use a Y-connector (not supplied) to connect to the right and left audio input jacks of the
N
TV. Alternatively, connect the cable to the "R" jack.
If your VCR is stereo, you must connect two cables.
Each VCR has a different back panel configuration.
N
When connecting a VCR, match the color of the connection terminal to the cable.
N

Connecting an Amplifier / DVD Home Theater

1. Connect Audio Cables between the AUDIO OUT [R-AUDIO-L] jacks on the TV and AUDIO IN [L-AUDIO-R] jacks on the Amplifier/
DVD Home Theater.
When an audio amplifier is connected to the AUDIO OUT [R-AUDIO-L] jacks terminals : Decrease the volume of the TV, and adjust
the volume level with the Amplifier's volume control.
Amplifier / DVD Home Theater
Each Amplifier / DVD Home Theater has a different back panel configuration.
N
When connecting an Amplifier / DVD Home Theater, match the color of the connection terminal to the cable.
N
5 Audio Cable(Not supplied)
4 Video Cable(Not supplied)
 Antenna cable(Not supplied)
Audio Cable (Not supplied)
English - 1
TV Rear Panel
TV Rear Panel