Two Touch Memory Operation; Mute Function; Do Not Disturb Function - Daewoo International DTC-360 Guia Del Usuario

2. Press SET/STORE/÷ key.
3. Press M1 key.
Make a call from one-touch memory
In on-hook or off-hook state, press M1 key, the stored number will be dialed out directly.

TWO TOUCH MEMORY OPERATION

Store number into two-touch memory
1. In on-hook state, pre-dial the desired number or review an incoming/ outgoing number you
want to store.
2. Press SET/STORE/÷ key. Press one of numeric keys (0-9, *, #)
Make a call from two-touch memory
In on-hook or off-hook state, press MEMORY key + numeric keys (0-9, *, #) key, the stored
number will be dialed out directly.

MUTE FUNCTION

When the phone has received a call and is ringing but you wouldn't like answer the call, then you
can press MUTE key to mute the ringing tone. The phone stops ringing.
SETTING RINGING TONE
1. In on-hook state, press HOLD key, LCD displays RING 01.
2. Press HOLD key continually to select your favorite music as the ringing tone, there are total 8
normal ringing tones for you selection.
3. Press DEL key to save and quit.
Note: RING OFF means no ringing tone for any incoming call and only the NEW LED will flicker
to remind there are missed calls. If you wouldn't like to be disturbed by incoming calls at some
time, you can set the phone to RING OFF, or let it in DND mode according to the section "DO NOT
DISTURB FUNCTION".

DO NOT DISTURB FUNCTION

1. At on-hook state, press VIP/P/DND key, LCD displays DND 08-00
2. Press UP/－ or DOWN/+ key to adjust DND time from 1~24 hours
3. Press VIP/P/DND key, the phone enters DND mode, and LCD starts to count down by minute
from the set time.
Once DND function is activated, the phone should only show the caller's numbers for 6 seconds
but no ringing tone for normal incoming calls. But for VIP number, it will ring as usual.
Note: After the DND time is counted down to 00-00, the phone will quit DND mode automatically.
Or during DND time counting down, press VIP/P/DND key to quit directly. In this case, LCD
displays "DND OFF" for 6 seconds and then comes back to standby state.
All manuals and user guides at all-guides.com
23