Unfolding The Stroller - WONDERFOLD W2S 2.0 Instrucciones De Ensamblaje

Assembly

Unfolding the Stroller

1. Standing on either side of the stroller, push smoothly outward on the upper front
and rear frame tubes to unfold the stroller.
EN
2. Ensure the upper lock on the right side of the stroller snaps into place.
3. Flip over the side pocket flaps to the outside on both sides of the stroller to cover
the frame joints.
Assembly & Removal of Front Wheels
1. Insert front wheels into the front wheel housings until you hear a click.
2. After attaching the front wheels, pull down on each wheel to confirm that they are
securely locked in place.
3. To unlock and release the wheel, use a tool with a narrow point to press the metal
button at the base of the stroller frame, then pull off the wheel.
Assembly of Rear Wheels
1. The C-shaped clamp comes pre-installed on the brake assembly. Release the
C-shaped clamp by pushing it out from the brake unit.
2. Insert the wheel axle in the brake assembly.
3. Insert the C-shaped clamp back into the rear wheel housing.
4. Pull the rear wheel axle to ensure that the rear wheel assembly is secure.
4
Assembly of Rear Wheels
1. Line up and connect the rear wheel assembly to the rear tube joint.
2. Check that the clips are in place on both sides of the wheel housing.
Canopy Assembly
1. Before assembling the canopy, make sure all four plastic clamps at the corners are open.
2. Insert the canopy poles into the frame slots on all four corners at the desired height.
3. Clasp to close all four plastic clamps. Canopy assembly complete.
Basket Assembly
1. Slide the basket hooks into the fixed slots on the frames under the handle bar tube.
2. Gently wiggle the basket to level it. Completed assembly shown in diagram 2.
EN
5