Garmin TT 15X Guia De Inicio Rapido página 4

Adding a Dog to the Alpha
1 If the dog collar device is on, turn off the dog collar device.
2 Hold the power key on the dog collar device until the device emits two series of beeps (about 2 seconds),
and then release the power button.
The status LED flashes rapidly in green. The dog collar device is now ready to be linked, or paired, with a
handheld device.
3 On the handheld device, select Dog List > Add Dog.
4 Select an option:
• If you are near the dog collar device, select Pair Collar, and follow the on-screen instructions.
• To pair a dog collar device by receiving the information from another handheld device, select Receive
from Handheld.
NOTE: To successfully pair the device, the other handheld device must be wirelessly sharing the dog collar
device information.
5 After successfully adding the dog collar device, enter the name of the dog, and select
Selecting and Installing the Contact Points
To prevent irritation from the contact points, remove the collar for at least eight hours out of every 24-hour
period.
Do not spray the device or collar with harsh chemicals including but not limited to flea or tick spray. Always
ensure that any flea or tick spray that is applied to the dog is completely dry before placing the collar on the dog.
Small amounts of harsh chemicals can damage the plastic components and collar laminate.
For best results, select the correct contact points based on your dog's coat.
1 Select the correct contact point length for your dog's coat type:
• For dogs with thicker coats, use the longer contact points.
• For dogs with shorter coats, use the shorter contact points.
2 If necessary, use the included wrench to remove the contact points.
3 Twist the contact points into the collar.
4 Tighten with the included wrench, but do not overtighten.
When you put the collar on the dog, make sure the contact points are tight against the neck.
4
Handheld Using Wireless Pairing
®
CAUTION
.
Quick Start Manual