Kunzer MPB 12-24/2000 Instrucciones página 11

CAUTION Always recharge the Emergency Starter after each time that it is used.
IMPORTANT Maintaining your vehicle's battery correctly prolongs its life. Once you reach your
destination, remember to connect your battery to a battery charger for vehicles to restore it to
maximum efficiency.
OVER RIDE FUNCTION, this mode is recommended when a vehicle with completely or
extremely flat, absent or cut-off battery needs to be started.
ATTENTION! SOME PROTECTION ARE NOT ACTIVE! TAKE CARE!
1. Always wear safety goggles and keep your face away from the battery when connecting it.
2. Check that the emergency starter is in the OFF position.
3. Check the voltage of the vehicle battery.
CAUTION: VOLTAGE INCOMPATIBILITY BETWEEN THE EMERGENCY STARTER AND THE
VOLTAGE OF THE VEHICLE'S ELECTRICAL SYSTEM CAN CAUSE EXPLOSIONS AND
DAMAGE THE VEHICLE, PRODUCT AND PEOPLE.
4.Be sure that the Battery Clips are disconnected. ATTENTION: If the Battery Clips are
connected, the "Err8" error, will showed.
5. Now PRESS "START/STOP", the display show "SET"
6. Select the correct tension, 12V or 24V, using the selection button
7. Set "OVER RIDE" function.
8. Now PRESS "START/STOP" for 3 seconds, until "ON" blink on the display.
9. Release the button and the display show "STRT"
10. Until 30" you can connect the clamps and start up the vehicle.
11. Identify the pole corresponding to the earth of the vehicle; this is generally connected to the
negative terminal.
12. CAUTION: never switch polarity. Always connect the output conductor with a red battery
clip (+) to the positive pole of the battery and the output conductor with a black battery clip (-)
to the vehicle's earth (ground). CAUTION: INVERTING POLARITY CAN CAUSE EXPLOSIONS,
DAMAGE THE VEHICLE, PRODUCT AND PEOPLE.
CAUTION: if the LED RED / REVERSE is set on, the polarity has been reversed. Disconnect the
battery clips from the vehicle and connect them correctly.
CAUTION: check that the cables of the Emergency Starter are far away from fans, from moving parts
and from the fuel conduit.
13. Once the vehicle has been started up, emergency starter automatically turns off after 30 seconds.
Otherwise press START/STOP button to turn off the emergency starter.
14. Disconnect the output conductor with the black battery clip from the earth of the vehicle and
replace output conductor with the black battery clip in its housing.
15. Disconnect the output conductor with the red battery clip from the positive terminal (+) of the
battery and return it immediately to its seat.
CAUTION: if you are unable to start the vehicle within 5 seconds, do not continue with the starting
attempt. Before trying to start up the vehicle again, let the Emergency Starter rest for at least 3
minutes to avoid damaging the appliance.
CAUTION Always recharge the Emergency Starter after each time that it is used.
Using the Emergency Starter as a 12V or 24V Memory Saver
1. Always wear safety goggles and keep your face away from the battery when connecting it.
2. Check that the emergency starter is in the OFF position.
3. Check the voltage of the vehicle battery.