Cleaning, Maintenance And Storage; Travelling With Smoothskin Bare Fit - CyDen SMOOTHSKIN Bare Fit Manual Del Usuario

If the precision head is damaged or missing any parts (e.g. magnet or reflector), then do not use.
If the precision head becomes uncomfortably hot during use, then stop treatment until it has cooled
down.
Follow all EYE SAFETY warnings (Section 3) when the precision head is fitted.
Follow the cleaning instructions (Section 11) for the precision head.
Magnet
Reflector
26
Top
11. CLEANING, MAINTENANCE, STORAGE
After treatment, always switch off SmoothSkin Bare Fit by unplugging from the electrical oulet.
After use, the handset, skin tone sensors and treatment window should
be inspected for damage and wiped down with a dry, lint free cloth.
WARNING: DO NOT
The glass filter can get hot during use.
clean the filter for at least 5 minutes after use to allow it to cool down.
NEVER use water or other cleaning fluids, as these can damage the
device leading to a potential safety hazard.
If necessary, the Reflector and Skin Tone Sensor can be carefully cleaned
by using a slightly damp cotton bud.
Store SmoothSkin Bare Fit in a cool, dry place. Make sure that the
treatment window and skin tone sensor on the handset are protected
from damage.
Regularly check the device (including cords) for visible signs of damage. In case of damage or cracks, stop using the device -
and visit the website for support details.

12. TRAVELLING WITH SMOOTHSKIN BARE FIT

The Power Supply unit of the SmoothSkin Bare Fit is universal and will work with all commonly encountered mains supplies.
Providing you have a suitable adaptor for the mains power cable plug, the SmoothSkin Bare Fit will operate as normal.
touch or
Skin Tone
Sensor
Reflector
27