Troubleshooting; Warranty; Labels And Symbols - CyDen SMOOTHSKIN Bare Fit Manual Del Usuario

13. TROUBLESHOOTING

PROBLEM
The Activation Button Lights on the Handset do not light up when placed
against your skin.
The Activation Button on the Handset lights up white when placed on the
skin, but the Handset fails to flash when the Activation Button is pressed.
The Activation Button Lights on the Handset are illuminated red
continuously, and the device will not function.
The SmoothSkin Bare Fit handset, treatment window, power supply or
cable are damaged, broken, cracked or appear defective.

14. WARRANTY

We grant a 2 year warranty on the product starting on the date of purchase. Within the warranty period, we will check faults in materials or
workmanship free of charge and replace the complete device, at our discretion.
This warranty extends to every country where this device is supplied by CyDen or its appointed distributor.
This warranty does not cover damage due to improper use, normal wear or use as well as defects that have a negligible effect on
the value or operation of the appliance. The warranty becomes void if repairs are undertaken by unauthorised persons and if original
SmoothSkin Bare Fit parts are not used. To obtain service within the warranty period, please visit our website:
To obtain service within the warranty period, please visit our website:
28
SOLUTION
Make sure the power supply is plugged in. Ensure the skin tone
sensor is fully pressed against the skin. Your skin could be too dark
for treatment. Check against the skin tone chart in the front of this
user guide.
There could be a fault with the device. Unplug the device and
restart. If the problem persists, visit the website for support details.
This indicates that there is a fault with the device. Stop using the
device and visit the website for support details.
DO NOT USE. If you are in any doubt about the safety of SmoothSkin
Bare Fit or suspect it is damaged in any way, it must not be used,
and you should visit the SmoothSkin website for more information.
www.smoothskin.com
www.smoothskin.com

15. LABELS AND SYMBOLS

SmoothSkin Bare Fit is marked with the following symbols:
FCC EMC compliance
Type BF Applied Part
for North America
Australia Regulatory
Class II Equipment
Compliance Mark
Follow Instructions for use
Trefoil compliance mark for
Ukraine
WEEE waste disposal mark of
the European Union
China RoHS environmental
protection use period
European Conformity
Marking
Warning Optical Radiation
from device may cause
Keep Dry
eye injury
NRTL Certification marking
FCC Statement:
NOTE: This equipment has been tested and found
to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against
harmful interference in a residential installation. This
equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However,
there is no guarantee that interference will not occur
in a particular installation. If this equipment does
cause harmful interference to radio or television
reception, which can be determined by turning the
equipment off and on, the user is encouraged to try
to correct the interference by one or more of the
following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment
and receiver.
•
Connect the equipment into an outlet on a
circuit different from that to which the receiver is
connected.
•
Consult the dealer or an experienced radio/TV
technician for help.
29