YATO YT-82842 Instrucciones página 6

GB
GENERAL SAFETY CONDITIONS
NOTE! Get acquainted with all the instructions below. Failure to observe them may lead to an electric shock, fi re or injuries. The notion of electric tool used in the instructions
applies to all the tools which are powered with electric current, both wire tools and wireless ones.
OBSERVE THE FOLLOWING INSTRUCTIONS
Safety precautions while using the electric tool
Before the battery is installed, make sure the switch is off . Installation of the battery when the switch is on may lead to accidents. Use solely the charger recommended by
the manufacturer. Using a charger designed for another type of battery may be a cause of fi re. The electric tool must be operated exclusively with the battery indicated by the
manufacturer. Using another battery may be a cause of fi re or injuries. When the battery is not used, it must be stored away from such metal objects as paper clips, coins, nails,
screws or other small metal elements, which might short-circuit the terminals. Short-circuited terminals of the battery may cause burns or fi re. Under adverse circumstances
liquid may leak from the battery; avoid any contact. In case of accidental contact with the liquid, rinse it with water. In case of eye contact, seek medical. The liquid leaking
from the battery may cause irritation or burns.
Repairs
Have the tool repaired solely by authorised workshops, where original spare parts are used. This will ensure the adequate safety of operation of the electric tool.
PREPARATION FOR WORK
ATTENTION! All the operations mentioned in this point must be realised with the power supply off .
- the battery must be disconnected from the tool!
Safety recommendations for battery loading
Attention! Before loading may start make sure the body of the charger, the cable and the plug are not broken or damaged. It is prohibited to use a damaged loading dock and
charger! For the purpose of loading batteries only the charging dock and the charger provided may be used. Using another charger may be a cause of fi re or damage the tool.
Batteries may be charged only in a dry room, protected from unauthorised persons, particularly children. Do not use the charging dock and the charger without permanent
supervision of an adult! If it is necessary to leave the room where loading is taking place, it is required to disconnect the charger from the mains, removing the charger from
the mains socket. In case when smoke comes out of the charger, or a strange smell is emitted, etc., it is required to immediately remove the plug of the charger from the
mains socket!
The drill and automatic return screwdriver is provided with an unloaded battery, so before work may commence, it is required to charge it following the procedure below,
using the charger and charging dock provided. Li-ION batteries do not show the so called "memory eff ect", so it is allowed to charge them at any moment. However, it is
recommended to discharge them during normal work, and then load them to their full capacity. If due to the nature of the task it is not possible to do so each time, then it is
required to do it at least from time to time. Under no circumstances is it allowed to discharge the batteries short-circuiting the electrodes, since this would cause irreversible
damage! It is also prohibited to check the load of the batteries, short-circuiting the electrodes for sparking.
O P E R A T I N G I N S T R U C T I O N
6