Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATION MANUAL AND INSTRUCTIONS
ISTRUZIONI PER L'USO
PERSONAL PROTECTIVE EQUIPMENT TO WEAR WHILE OPERATING TYRE INFLATOR
Failure to observe the following warnings may result in physical injury and/or disease.
ALWAYS WEAR EYE PROTECTION WHILE OPERATING PNEUMATIC TOOL OR
PERFORMING MAINTENANCE JOBS
PRODUCT SPECIFICATIONS
MEASURING RANGE
RESOLUTION
MAX. OPERATING PRESSURE
AIR HOSE LENGTH
THREADED FITTING
BATTERIES
INSTRUCTIONS
Battery installation/replacement
1. Lift guard
4. Close back battery compartment cover
Note: If voltage is lower than 2.4 V, the flat battery signal on top left will be blinking, to remind the user that the battery
should be replaced.
Air supply connection
For optimal use of the tyre inflator, always keep to a maximum pressure of 15 bar, as measured at the tool inlet. Feed the tool
with clean, condensate-free air. Excessively high pressure or humidity in supply air may damage the tool.
USE
Fit the inflator connector onto the valve of the tyre to check.
Press the on/unit/light key to operate the tool.
The display will show the measured pressure.
6
2. Open battery compartment cover
5. Close back guard
0 ÷ 12 bar (0-175 PSI;0- 1200KPa;0- 12,23KGF)
0.01 bar (14.50 PSI; 100 KPa; 1.02 KGF)
15 bar (218 PSI; 1500KPa; 15.29 KGF)
450 mm
1/4" GAS
2 batteries AAA
3. Fit in batteries
EN
I
Publicidad
Tabla de contenido
