Expondo Royal Catering RCPG 51 Manual De Instrucciones página 27

have access to the power plug. The power cord connected to the appliance must
be properly grounded and correspond to the technical details on the product label.
Only use the device in a horizontal position. Do not shake the device.
Disassemble the device and all its components and clean them before the first use.
The hotplate is coated with maintenance grease. Before first use, wash the hotplate
with water and dishwashing liquid, dry with a paper towel and then coat with
vegetable oil.
3.3.
1. Ground the device housing, use the grounding terminal located on the back
of the griddle.
2. Before connecting the device to the power supply, always check that the
temperature control knob is set to "0". For models with an ON / OFF switch,
make sure it is in the OFF position.
3. Connect the power cord to a power outlet, The green power lamp will come
on.
• For models with an ON / OFF switch, set the ON / OFF switch to the ON
position.
• In models with two hobs, each of them has a separate power cord, thermal
protection and controls.
4. Use the temperature control knob to set the preferred temperature for the
hob to reach. The heating indicator lamp will come on and will go out after
the set temperature is reached. For two hob griddles: the knob and lamp
indicators for the left-hand hob are on the left and for the right-hand hob on
the right. The thermostat will keep the temperature constant.
Note: When used for the first time, the heating elements may emit a small
amount of smoke.
5. ATTENTION! Use appropriate utensils to put on and take off food to be
grilled. Do not use metal utensils – these may damage the heating surface.
6. NOTE: After the first heating, the grill may darken more or less regularly. This
is quite normal: the plate is made out of cast iron and the surface oxidizes.
7. Regularly check the fill level of the collecting drawer to avoid overfilling it.
8. When you have finished using the machine, perform the following steps in
the order presented:
a) set the thermostat to the "0" position,
b) for models with an ON / OFF switch, set the switch to the OFF position,
c) disconnect the device from the power supply.
Device use