Care And Maintenance; Cleaning Your Appliance; Cleaning The Appliance; Troubleshooting Guide - Avanti PDR36L34G Manual De Instrucciones

12v dc – refrigerador portátil para casa rodante/ camion
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Cleaning The Appliance

·
Unplug the unit and remove contents.
·
Wash the inside with a warm water and baking soda solution. The solution should be about 2
tablespoons of baking soda to a quart of water.
·
Remove the drain plug to drain the excess liquids.
·
The outside of the unit should be cleaned with mild detergent and warm water.
CAUTION: Failure to unplug the appliance could result in electrical shock or personal injury.
Defrosting the unit
Humidity can form frost in the interior of the unit which will affect the cooling performance.
Defrost the unit regularly to avoid any possible issues.
a) Turn off the unit
b) Remove the contents
c) Open the doors and allow the frost to defrost naturally, do not use any sharp or hard objects to
remove the frost from the interior of the unit as this can damage the unit.
d) Remove the drain plug.
e) Wipe off the excess water
f)
Replace the drain plug
You can solve many common appliance problems easily, saving you the cost of a possible service
call. Try the suggestions below to see if you can solve the problem before calling for service.
PROBLEM
Refrigerator does not operate.
Refrigerator does not cool.
Refrigerator is not cold
enough.
Error Code F1
Error Code F2
Error Code F3
Error Code F4
Error Code F5
Error Code F6
Error Code F7 or F8

CARE AND MAINTENANCE

TROUBLESHOOTING GUIDE

Not plugged in.
The circuit breaker tripped or blown fuse.
The refrigerator temperature control is set at "OFF"
The room temperature is hotter than normal.
The door is opened too often.
The door is not closed completely.
The temperature control is not set correctly.
A large amount of warm or hot food has been stored recently; wait
for the refrigerator to reach is set temperature.
Low Voltage to unit
Adjust battery protection from H to M or from M to L
Condenser Fan Overload
Disconnect unit for 30 minutes and Restart
Compressor Start Too Frequently
Disconnect unit for 30 minutes and Restart
Compressor not starting
Disconnect unit for 30 minutes and Restart
Compressor Overheating / Electronics
Disconnect unit for 30 minutes and Restart
Controller Error
Disconnect unit for 30 minutes and Restart
Temperature Sensor Fault
Contact Customer Service
11
POSSIBLE CAUSE

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Pdr50l34g

Tabla de contenido