Changing Battery; Charging Battery; Replacing Battery - GP CHR35 Instrucciones De Uso

Read the instruction manual thoroughly before use.
Keep the manual for future reference.
Operating instructions

Changing battery:

1. Unscrew the tail cap (A)
2. Remove discharged battery
3. Insert fully charged battery taking care to install according to polarity markings +/-
and replace tail cap (A) securely

Charging battery:

1. Pull back the rubber Micro USB cover (B) and plug the Micro USB connector to the
charging port of the headlamp. Plug the USB connector to a power source such as a
computer, power bank charger, USB wall socket adapter or USB car charger.
2. LED indicator light:
Green LED: Charging completed
3. Disconnect the USB cable when fully charged and carefully replace the rubber Micro
USB cover (B)
Operation:
• Full press switch -> High -> Medium -> Low -> Off (Cycle repeats)
• Double press switch whether ON or OFF for strobe
• If the light is on for longer than 5 seconds, when the switch is pressed again the
headlamp will turn off
• Accessing Turbo output at anytime. Press switch and hold for 1 second. Press again
light will go off
Removing headlamp from holder
The headlamp can be quickly and easily removed from the holder by unclipping the
rubber band from the clip points (C). The headlamp can know be used as a handheld
ashlight. The clip allows it to be carried in a pocket too
Safety Instructions and Warnings
Use the device in a temperature range between 0 and 40°C and avoid exposure to direct
heat and constant sunlight.
This appliance is not intended for use by young children or in rm persons unless they
have been adequately supervised by a responsible person to ensure that they can use
the appliance safety. Young children should be supervised to ensure that they do not play
with the appliance.
Use 1 x GP Li-ion 18650 battery with integrated overcharge and over-discharge
Protection Circuit Module (PCM). Failure to use dedicated GP Li-ion 18650 batteries for
the application device may result in damage to the ashlight and/or batteries. Users may
experience risks if damaged or short circuited cells are installed.
Risk of re and burns. Do not recharge, disassemble, heat above 40°C, or incinerate.
Keep battery out of reach of children and in original package until ready to use.
Dispose of used batteries promptly.

Replacing battery

When changing batteries rst switch off ashlight before removing tail cap (A) and install new
batteries in the appropriate battery holder. Screw the tail cap when batteries have been
correctly tted according to prescribed polarity markings on the battery holder (+) and (-). Care
should be taken that the batteries are installed in accordance with the battery polarity.
Do not dispose of electrical appliances as unsorted municipal waste, use separate collection facilities.
Contact your local government for information regarding the collection systems available. If electrical
appliances are disposed of in landfills or dumps, hazardous substances can leak into the groundwater
and get into the food chain, damaging your health and well-being.
Red LED: Charging in progress
GB GB