Kinderkraft MINKY Instrucciones De Operación página 16

• This product is not intended for prolonged periods of sleeping.
• Never use the product on elevated surfaces (e.g. on a table).
• Always use the restraint system (safety harness).
• To avoid injury ensure that children are kept away when
unfolding and folding this product.
• Do not let children play with this product (it does not apply
to toys attached to the toy bar).
• Do not move or lift this product with the baby inside it.
• Never use the baby toy bar as a handle to carry the
product.
• Keep the product away from open fire and other heat sources such as electric
heaters, gas heaters, etc.
Do not use the product if any parts are damaged or missing.
Do not use any accessories or spare parts other than those recommended by the
manufacturer.
The adapter used with the swing should be regularly checked for damage to the cord,
plug, housing and other parts. In case of damage to the parts, stop using the adapter.
The swing should only be used with an adapter recommended by the manufacturer.
Safe battery use
Disposable batteries are not suitable for charging. Do not mix different types of batteries, or
new batteries with used ones. Insert the batteries according to their proper polarity. Dead
batteries must be removed from the product. Do not short-circuit power poles. The batteries
can be charged only under adult supervision.
Technical specifications:
Battery-powered (INPUT1): 3 pcs. x C 1.5 V
Adapter-powered (INPUT2): 5V
Bouncer assembly:
Follow Figures B1-B10.
Start tightening of the cover from the backrest, insert the other part (A3) in the lower part of
the cover (B6). Place the ends of A3 tubes in the holes as shown in Fig. B6. Push the tube ends
in the holes towards the bottom of the seat until properly latched. Secure the seat cover with
the straps located under the seat (B7), and make sure that the assembly was performed
correctly and the whole fits tightly.
(not included)
, 2A
16