Operating A Component Stored In The Preset Memory - Denon AVR-2106 Instrucciones De Operación

ENGLISH
Advanced Operation
OFF
NUMBER
MODE 1
Preset memory
• DENON and other makes of components can be operated by
setting the preset memory.
• This remote control unit can be used to operate components of
other manufacturers without using the learning function by
registering the manufacturer of the component as shown in the
list of preset codes ( End of this manual).
• Operation is not possible for some models.
1
MODE 1
Set the switch to "AUDIO" or "VIDEO".
Set to the AUDIO side for the CD, Tape deck or CDR/MD
position, and to the VIDEO side for the DVD/VDP,
DBS/CABLE, VCR or TV position.
2
MODE 2
Set the switch to the component to be
registered.
3
Press the
ON SOURCE
same time.
• The indicator starts flashing.
4
Referring to the included list of preset codes,
press the
code (a 3-digit number) for the manufacturer of
the component whose signals you want to store
in the memory.
MODE 2
5
To store the codes of another component in the
memory, repeat steps 1 to 4.
• The signals for the pressed buttons are emitted while setting
the preset memory. To avoid accidental operation, cover the
remote control unit's transmitting window while setting the
preset memory.
• Depending on the model and year of manufacture, this function
cannot be used for some models, even if they are of makes
listed in the list of preset codes.
• Some manufacturers use more than one type of remote control
code. Refer to the included list of preset codes to change the
number and verify correct operation.
• The preset memory can be set for one component only among
the following: CDR/MD, DVD/VDP and DBS/CABLE.
2 The preset codes are as follows upon shipment from the
factory and after resetting:
• TV, VCR .........................................HITACHI
• CD, TAPE.......................................DENON
• CDR/MD ........................................DENON (CDR)
• DVD/VDP .......................................DENON (DVD)
• DBS/CABLE...................................ABC (CABLE)
ON/SOURCE OFF
and button at the
NUMBER
buttons to input the preset
31
ENGLISH
Operating a component stored in the preset
memory
1
MODE 1
Set the switch to "AUDIO" or "VIDEO".
Set to the AUDIO side for the CD, Tape deck or CDR/MD
position, and to the VIDEO side for the DVD/VDP,
DBS/CABLE, VCR or TV position.
2
MODE 2
Set the switch to the component you
want to operate.
3
Operate the component.
For details, refer to the component's operating instructions.
Some models cannot be operated with this remote control
unit.
Advanced Operation