Warranty Registration - Tripp-Lite OMNISMART OMNIVS500 Manual Del Usuario

Controls
continued

Warranty Registration

WARRANTY REGISTRATION
Visit www.tripplite.com/warranty today to register the warranty for your new Tripp Lite product. You'll be automatically entered
into a drawing for a chance to win a FREE Tripp Lite product!*
* No purchase necessary. Void where prohibited. Some restrictions apply. Valid in the U.S. only. See website for details.
FCC Part 68 Notice (United States Only)
If your Modem/Fax Protection causes harm to the telephone network, the telephone company may temporarily discontinue
your service. If possible, they will notify you in advance. If advance notice isn't practical, you will be notified as soon as
possible. You will be advised of your right to file a complaint with the FCC. Your telephone company may make changes in its
facilities, equipment, operations or procedures that could affect the proper operation of your equipment. If it does, you will be
given advance notice to give you an opportunity to maintain uninterrupted service. If you experience trouble with this
equipment's Modem/Fax Protection, please call Tripp Lite Technical Support at (773) 869-1234 for repair/warranty
information. The telephone company may ask you to disconnect this equipment from the network until the problem has been
corrected or you are sure the equipment is not malfunctioning. There are no repairs that can be made by the customer to the
Modem/Fax Protection. This equipment may not be used on coin service provided by the telephone company. Connection to
party lines is subject to state tariffs. (Contact your state public utility commission or corporation commission for information.)
FCC Radio/TV Interference Notice (U.S. only)
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy, and if not installed and used in
accordance with the instruction manual, may cause interference to radio communications. However, there is no guarantee
that interference will not occur in a particualr installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct
the interference using one or more ofthe following measures: reorient or relocate the receiving antenna; increase the
separation between the equipment and the receiver; connect the equipment into an outlet on a circuit different from that
which the receiver is connected; consult the dealer or an experienced radio/television technician for help.
200912039 93-2421.indb 7
All manuals and user guides at all-guides.com
Tel/DSL Protection Jacks (select models): stop surges on a
single phone or fax line. Connecting your equipment to these
jacks is optional. The UPS will work properly without this
connection.
Battery Replacement Door: Under normal conditions, the
original battery in your UPS will last several years. Battery
replacement should be performed only by qualified service
personnel. Refer to "Battery Warnings" in the Safety section.
Should your UPS require battery replacement, visit Tripp Lite
on the Web at www.tripplite.com/support/battery/index.cfm to
locate the specific replacement battery for your UPS.
Power Sensitivity: this dial is normally set fully
counterclockwise, which enables the UPS to protect against
waveform distortions in its AC input. When such distortion
occurs, the UPS will normally switch to providing PWM
sinewave power from its battery reserves for as long as the
distortion is present. You may be able to reduce how often your
UPS switches to battery due to waveform distortion by
experimenting with different settings for this dial. As the dial is
turned clockwise, the UPS becomes more tolerant of variations
in its input power's AC waveform.
7
12/15/2009 4:05:09 PM