Chacon 34045 Manual De Uso página 26

3. To exit pairing mode, press and hold the learn button for 3 seconds. You will hear a double «beep».
NOTE: A maximum of 32 transmitters can be paired to a main unit.
3. Wall installation of the control unit
1. Once you have installed the batteries, choose a location for your
motion detector.
2. Fix the bracket to the wall using the supplied dowels and screws.
3. Fit the sensor onto the bracket and then choose the best angle for
the sensor to have the best possible field of view.
Recommended installation height:
Maximum 160cm and minimum 30cm.
NOTE: Adjust the installation angle so that it faces downwards.
4. Mode on the remote control
The remote control has an «On» button to activate the alarm and an «Off» button to deactivate it.
On the side of the remote control there are two inscriptions «HOME» and «AWAY».
a) Home mode: When you select «HOME» mode with the switch, it means that you are at home and don't want to be
disturbed. Slide the switch on the remote control marked «HOME» and press the «On» button.
b) AWAY mode: When you select the «AWAY» mode with the switch, it means that you are leaving your home and
want to turn off your alarm. Slide the switch on the remote control marked «AWAY» and press the «On» button
NOTE: In «home» mode, all motion detectors are disabled.
5. Setting up the personal code
Once you have placed your batteries, you have 15 seconds to choose a four-digit code. If you have not had time to
enter your personal code, the code 1234 will be saved by default.
Note: Each time you install batteries, you will need to set up your 4-digit code again.
6. Functionality of the keypad
a) HOME Mode: Enter your 4-digit code, then press the «1» button. You will hear a «beep» to indicate that the alarm
will enter «home» mode after 30 seconds.
NOTE: In this case, the motion detection function is disabled. Only the opening detector will trigger an alarm. This
mode is also available on the remote control.
EN
100° 80°
100°
2m 4m
60° 20°
6m 8 m