Hilti AG 5D-22 Manual De Instrucciones Original página 16

Status
Two (2) LEDs show constantly green
One (1) LED shows constantly green
One (1) LED slow-flashes green
One (1) LED quick-flashes green
One (1) LED quick-flashes yellow
One (1) LED shows yellow
One (1) LED quick-flashes red
3.9.2 Indicators showing the battery's state of health
To check the battery's state of health, press the release button and hold it down for longer than three
seconds. The system does not detect a potential malfunction of the battery due to misuse, for example
battery dropped or pierced, external heat damage, etc.
Status
All LEDs show in sequence, followed by one (1)
LED showing constantly green.
All LEDs show in sequence, followed by one (1)
LED quick-flashing yellow.
All LEDs show in sequence, followed by one (1)
LED showing constantly red.
4 Consumables
Use only synthetic resin-bonded, fiber-reinforced wheels with a maximum Ø of 5" approved for a rotational
speed of at least 11000 rpm and a peripheral speed of 80 m/s.
The maximum permissible grinding wheel thickness is 1/4" and the maximum permissible cut-off wheel
thickness is 1/8".
ATTENTION! When cutting or slitting with abrasive cut-off wheels always use the standard guard with
the additional front cover, or a fully enclosing dust hood.
Wheels
Type
Abrasive cut-off wheel
Diamond cut-off wheel
Abrasive grinding wheel
Diamond grinding wheel
Wire brush
Abrasive resin-fiber wheel
10 English
Meaning
State of charge: 50 % to 26 %
State of charge: 25 % to 10 %
State of charge: < 10 %
The Li-ion battery is completely discharged.
Recharge the battery.
If the LED again starts quick-flashing after the bat-
tery has been charged, consult Hilti Service.
The Li-ion battery or the product in which it is in-
serted is overloaded, too hot or too cold, or experi-
encing some other fault.
Bring the product and the battery to the recom-
mended working temperature and do not overload
the product when it is in use.
If the message persists, consult Hilti Service.
The Li-ion battery and the product in which it is
inserted are not compatible. Consult Hilti Service.
The Li-ion battery is locked and cannot be used.
Consult Hilti Service.
Meaning
The battery can remain in use.
The check to ascertain the battery's state of health
did not complete. Repeat the procedure, or consult
Hilti Service.
If a connected product can still be used, the re-
maining battery capacity is below 50 %.
If a connected product can no longer be used, the
battery has reached the end of its useful life and
has to be replaced. Consult Hilti Service.
Application Designation
Cutting, slitting AC­D
Cutting, slitting DC­D (SPX, SP, P)
Rough grinding AG­D, AF­D, AN­D
Rough grinding DG­CW (SPX, SP,
P)
Wire brushes 3CS, 4CS, 3SS,
4SS
Rough grinding AP-D
2272033
Material
Metal
Mineral
Metal
Mineral
Metal
Metal
*2272033*