Key To Symbols - Beta 1900S Instrucciones

INSTRUCTIONS FOR USE ISTRUZIONI PER L'USO

KEY TO SYMBOLS

A) metal fixing bracket, revolving
B) air/water outlet
C) hose winding limiting device
USE
Hose pulling
Pull the hose as follows:
• pull the hose by hand until the required length is achieved;
• the hose is locked by means of the spring ratchet, which is activated in certain pulling points of the hose,
which can be heard through the mechanical noise of the engaged ratchet;
• The automatic safety catch locks the hose, thereby preventing it from winding.
Hose winding
Wind the hose as follows:
• pull the hose by hand to automatically release the ratchet;
• ease the hose while winding it, being careful to avoid interference with persons or things;
• the hose is fitted with a hose winding limiting device which stops it, thereby preventing it from winding completely.
Safety catch disconnection
The safety catch of the hose reel can be cut out as follows:
During this operation, the hose must be completely rewound.
• open the side cover on the hose reel by unscrewing its fixing screws;
• release the ratchet spring from fixing point 1 and hook it to fixing point 0;
(see below picture)
• put back the cover, replacing and tightening the screws correctly.
Always disconnect air supply before carrying out any jobs on the hose reel.
Filtering system
The hose reel should be connected to a compressed air supply system complete with filtering system for solid particles.
.
8
EN I