SEVERIN SM 9688 Instrucciones De Uso página 11

∙ No responsibility is accepted if damage
results from improper use, or if these
instructions are not complied with.
Before using for the fi rst time
Remove any packaging materials and check
that all components are present.
Before the appliance is used for the fi rst
time, or after extended periods of non-use, it
should be thoroughly cleaned as described
in the section Cleaning and care.
Operation
We recommend the use of long-life milk
(UHT) with a high protein content. For best
results, the milk should be taken from the
refrigerator immediately before frothing.
The underside of the container and the contact
area on the inside of the base must be clean
and dry.
Choosing the stirring head
∙ Use the smooth stirring head to heat up
milk.
∙ For frothing and heating milk at the same
time, use the serrated head.
∙ For cold-frothing milk, also use the
serrated head.
∙ The head not currently in use can be
stored in the rear of the housing.
Fill amounts
∙ Always observe the minimum mark and
ensure the container is fi lled with at least
120 ml milk.
∙ For frothing, fi ll the container to a
maximum of 350 ml (lower max mark
∙ For heating, fi ll the container to a
maximum of 700 ml (upper max mark
All manuals and user guides at all-guides.com
Heating up or frothing milk
∙ Place the container onto the base.
∙ Remove the lid from the milk container.
∙ Place the appropriate head onto the
∙ Put the required amount of milk into the
∙ Place the lid on the container.
∙ Use the temperature control to set the
∙ Insert the plug into a suitable wall socket.
∙ Press the On/Off switch.
∙ A double beep is heard, the indicator lamp
∙ The stirring process begins. Once the
∙ The main indicator lamp fl ashes, and a
∙ You can now remove the milk container
∙ The cooling system continues to run for
∙ The power cord can now be disconnected
Remarks
If the appliance has not been disconnected
from the mains , the On/Off switch must be
). pressed twice to start a new operating cycle.
After a heating cycle, the appliance
). cannot start a new stirring and heating
cycle immediately, but must be allowed to
mounting protrusion inside the bottom of
the container.
container.
desired temperature or to select the cold-
frothing function (COLD).
A beep signal is heard and the main
indicator lamp starts fl ashing.
remains on and the motor cooling system
starts up.
milk is suffi ciently hot or the cold-frothing
process is complete, both heating and
stirring processes stop automatically.
number of beep signals are heard.
from the base. Use a suitable spoon to
take off the milk froth.
a brief period. The main indicator lamp
stops fl ashing after about three minutes.
from the socket.
11