BaByliss Wet N Dry pro 230 Manual página 6

Temperature
130°C green
LED
155°C yellow
LED
155°C yellow
LED
180°C orange
LED
180°C orange
LED
205°C red LED
230°C red LED
• Take a section about 2 to 3 cm
wide and place it between the
two heating plates, near the roots
of the hair. To avoid any risk of
burn from the steam, make sure
you do not point the straighte-
ner's steam vents at your face,
scalp or hands.
• Press the straightener handles
together, hold to keep the sec-
tion between the plates and glide
slowly from the roots to the tips.
• Note! When you are straightening,
you might hear some sizzling
and see some steam. Do not be
concerned, this could be because of
evaporation of the sebum, some re-
sidual hair products (leave-in hair
care, hairspray, etc.) or excess water
that is evaporating from your hair.
• Take up a new section of hair
and continue until your hair is all
straight.
• Repeat again if necessary, then
release the straightener.
• For perfect straightening, use the
untangling comb. Your section of
Hair type
Fine, bleached
and/or dama-
ged hair
Normal, colou-
red and/or wavy
hair
Thick and/or
very curly hair
hair can be spread evenly in the
straightener and be untangled
easily. If you do not want to use
the comb, you can remove it by
sliding it off the straighteners.
Wait until the unit has cooled
completely before removing the
comb.
• If your roots are still a little damp
or if you would like to produce
more volume, bend forward and
gently dry with a hairdryer.
• Give your hair the final touch.
Set your straightened hair with
a light misting of hairspray or a
little mousse, but certainly do not
brush your hair.
• The pro 230 Wet N' Dry straighte-
ner can also be used on dry hair.
Follow the above instructions,
but dry your hair first.
To shape your hair
The BaByliss pro 230 Wet N' Dry
straightener may also be used to
accent certain sections (fringe, tips
turned in or out, etc.) and to lift the
roots.
• To lift the roots, take up a section
and hold it straight out from the
scalp, close the plates on the
section and rotate the unit to the
front to give the roots maximum
volume. Hold for a few seconds,
then gently straighten from the
roots to the tips.
• To turn the tips under, use as des-
cribed above but turn the unit
under (as you would with a brush
when blow drying). Keep in place
for a few seconds then release.
• To turn your tips out, do the same,
6