Lenco DIR-200 Manual Del Usuario página 26

•
•
5.8. 5.8. AUX AUX AUX IN IN IN IN
5.8. AUX 5.8.
Aux in mode plays audio file from an external source such as an MP3
player.
To play audio file with Aux in mode follow the steps below:
Turn the volume low on both the device and, if adjustable, the
o
audio source device.
Connect the external audio source to the 3.5mm Audio in socket
o
at the rear of the device.
Press
o
Adjust the volume of the device (and, if necessary, the audio
o
source device) as required.
5.9. 5.9. Sleep Sleep
5.9. Sleep 5.9. Sleep
To set the sleep timer, select Sleep in the Main menu or press
remote control. Choose sleep period option from Sleep OFF, 15 MINS,
30 MINS, 45 MINS or 60 MINS.
The system returns to the main menu after you selected a desired
sleep period option. Press and hold MENU/INFO
MENU MENU
MENU MENU on the remote control to return to the now playing screen.
5.10. 5.10. Alarm Alarm
5.10. 5.10. Alarm Alarm
There are two available wake-up alarms with snooze function, and a
sleep function which can turn the system off after a set period. Each
Scan settings
FM scans is default to stop at any available station. This may
result in a poor signal-to-noise ratio (hiss) from weak stations.
To change the scan settings to stop only at stations with good
signal strength, select Yes after choosing Strong station only?
Audio settings
All stereo stations are reproduced in stations, this may result
in a poor signal-to-noise ratio (hiss). To play weak stations in
mono, select FM weak reception: Listen in mono only and
then YES.
/MODE
/MODE or select AUX IN in the Main menu. /MODE /MODE
MENU/INFO
MENU/INFO on the device or MENU/INFO
26
on the