Power On - TEXA TTC Manual

CHARGING FROM A PC
Proceed as follows:
1. Turn on the PC.
Connect the USB cable to the tool.
2.
3. Connect the USB cable to the PC.
CHARGING FROM THE MAINS
Proceed as follows:
Connect the USB cable to the tool.
1.
2. Connect the USB cable to the battery charger.
3. Connect the battery charger to the mains.
Information about the power supply status is provided both by the tool and
by the red LED on the battery charger.

7.2 Power on

To turn on the tool proceed as follows:
Hold down the power button for about 2 seconds until the tool beeps and
the LED flashes.
When you switch on the initial screen with the logo appears.
The flashing message "Press to start ..." shows that the tool is ready for
use.
en
51