Bosch CET3-10 Instrucciones De Funcionamiento Y Seguridad página 4

Follow all recommendations for sizes of hoses, fittings
and other compressed air accessories. Improperly
sized fitting or components may result in the risk of
injury or property damage
Never move the compressor by pulling on a hose. The
compressor, air fittings and the air hose may become
damaged and burst.
Check air supply lines for restrictions before adjusting
tool. Air volume is as important as air pressure. Re-
stricted air flow will prevent the tools from operating
as designed.
Never exceed the maximum allowable pressure rating
marked on tools and attachments. Do not use com-
pressor to inflate low pressure objects such as toys.
Exceeding the maximum recommended pressure of
tools and attachments can cause them to burst. The
correct pressure is the lowest pressure that will do
the job.
Drain condensate from air tanks daily with drain valve.
Draining water from the air compressor reduces the
risk of the air tank corrosion. Corroded air tanks
have an increased the risk of bursting.
Stop the compressor, drain air tanks and allow it to
cool before making adjustments, moving the compres-
sor, leaving the work area, performing maintenance or
storing the compressor. Such precautionary safety
measures reduce a risk of injury.
Do not modify this compressor or operate compressor
at pressures or speeds greater than designed. Any al-
teration or modification is a misuse and may result in
a dangerous condition such as fire or bursting.
When transporting compressor, keep level and place
on a protective mat. Do not place compressor on its
side. Such precautions reduce the risk of fire or dan-
ger to personnel from oil fumes.
4
All manuals and user guides at all-guides.com
Maintenance performed by unauthorized personnel
may result in misplacing of the internal components
which could cause serious hazard. We recommend
that all compressor service be performed by a BO-
SCH factory service center or authorized BOSCH
service station.
Develop a periodic maintenance schedule for your
tool. When cleaning a compressor be careful not to
disassemble any portion of the tool since internal
components may be misplaced or safety components
may be improperly mounted. Certain cleaning agents
such as gasoline, carbon tetrachloride, ammonia, etc.
may damage plastic parts and o-rings.
When servicing the compressor, use only recom-
mended BOSCH replacement parts. Follow instruc-
tions in the Maintenance section of this manual. Use
of unauthorized parts or failure to follow Maintenance
Instructions can cause a risk of injury.
Replace missing or damaged warning labels. Refer to
schematic for correct placement and part number.
Maintain compressor with care. Keep the compressor
clean and lubricated. Properly maintained tools are
less likely to break and cause injury. Any alteration
or modification is a misuse and may result in a dan-
gerous condition. Clean the tool at least daily and lu-
bricate as required.
When not in use, store the compressor out of reach of
children and other personnel unfamiliar with compres-
sor operation. When not in use, the tool should be
disconnected and stored in a dry place. Vent the air
tank. Keep out of reach of children. Lock the storage
area. Compressor can be dangerous in the hands of
users unfamiliar with its operation.
serVICe