Connect Wires - Philips CE135BT Manual Del Usuario

Connect wires

Note
•
Make sure that all loose leads are insulated with
electrical tape.
•
Consult a professional to connect wires as instructed
below.
1
Check the car's wiring carefully and
connect them to the the ISO male
connectors.
ISO male
connectors
a Green strip, black-
edged green strip
b White strip, black-
edged white strip
c Gray strip, black-
edged gray strip
d Purple strip, black-
edged purple strip
e Red strip
f Blue strip
g White-edged blue
strip
Connect to
Rear left speaker
Front left speaker
Front right speaker
Rear right speaker
Ignition key +12V
DC when ON/
ACC
Motor/electric
antenna relay
control lead
Amplifier relay
control lead
h Black strip
i Yellow strip
2
Connect the antenna and amplifier as
illustrated, if applicable.
e
L
REAR
R
d c b
Sockets on rear External sockets or
panel connectors
1 For ISO male As indicated above
connectors
2 REAR L Rear left speaker
REAR R
3 Rear right speaker
ANTENNA
4 Antenna
5 purple strip OE remote control
module
Tip
•
The pin arrangement for the ISO connectors depends
on the type of your vehicle. To avoid damage to the
unit, connect properly.
Ground
To the +12V car
battery which is
energized at all
times
a
EN
7