Nowsonic TITAN 520 Instrucciones De Uso página 5

TITAN 520
EN
User manual
Rear Panel Controls
1
1) Balanced XLR Inputs
Two 3-pin XLR input connectors are provided.
2) MODE Selection
Three modi are provided. Stereo, Parallel and Bridge.
3) 2-Way Binding Post Jacks
One pair per channel, accepts banana plugs or bare wire.
Note: Binding post outputs on European models come with safety
plugs installed to prevent European power plugs from being inserted.
Please use the side entry positions with European models.
Get Started
Stereo Mode
This is the default mode the amplifier is set to from the factory.
Connect left/right signal source to channel 1 and channel 2 using
either the XLR, ¼-inch or RCA connectors.
Connect a speaker to each channel output using Speakon, Banana
Plugs or bare wire.
All manuals and user guides at all-guides.com
2
4 5
3
4) ¼-inch Inputs
Two ¼-inch input connectors are provided.
5) RCA(Phono) Inputs
Two RCA inputs are provided. (One per channel)
6) 4-Pole Speakon Output Connectors
These two connectors accept 2-pole or 4-pole Speakon connectors.
The channel connector is wired for both channels so it can be used
for bridged mono wiring or stereo wiring of two speakers to a single
Speakon.
6
www.nowsonic.com
1
6 7