Gewiss Chorus GW 10 746 Manual Del Usuario página 16

All manuals and user guides at all-guides.com
Insert the device in a 3-module Chorus support, making sure the temperature probe is
on the left.
Finish installation (figure H) with a KNX Chorus touch plate.
The device does not require any maintenance. If cleaning is necessary, use a dry cloth
following the steps explained below.
CLEANING FUNCTION
This function allows the sensors to be inhibited momentarily so the glass plate can be
cleaned without any unwanted bus commands being sent. This function can be activated
or deactivated with the following procedure.
Enabling:
• touch channels 2 and 5 (or 3 and 4) simultaneously for at least 6 seconds
• wait until you hear a short beep
• wait for the blue LEDs of the two selected channels to blink (1s ON, 1s OFF); the other
LEDs stay off.
Disabling:
• touch channels 2 and 5 (or 3 and 4) simultaneously for at least 6 seconds or
• wait about 20s after which a short beep sounds
• wait for the blinking to stop and, if it is the case, the status or night time indications to
be restored preceding cleaning.
The cleaning function can be disabled via ETS and it can be activated/deactivated with
a command from the bus and its duration is parameterisable.
INSTALLATION
Completion
Maintenance
16