Num'axes EYENIMAL SMART BLOOM Manual De Instrucciones página 10

Indicator lights instructions
A. FILTER: when this indicator light is blinking, turn the power off and replace the filter. Long press the reset key to reboot product.
B. NORMAL MODE/SMART MODE: in normal mode, this indicator lights up in white. In smart mode (regular intervals), the
indicator lights up in blue. When the water level is low, it will blink to prompt you to add water.
C. RADAR MODE: in radar mode, this indicator lights up in white. When the water level is low, it will blink to prompt you to add
water.
D. LED/RESET: press this button to turn the night light on. After replacing the filter, press the reset button for 2 seconds until the
indicator stops blinking.
E. ON/OFF SWITCH: press this button to turn product on and to change operating mode. Long-press to turn product off.
Normal
Smart (regular intervals)
Radar
Operating modes
Keeps working continuously.
Works for 2 minutes then switches to
standby for 3 minutes.
Works for 90 seconds whenever your
pet enters the sensor area. Pauses
for 15 seconds if the pet stays into
the sensor area.
Filter replacement time
30 days
75 days
30 days
10