Product Description; Overview; Installation And Connection; Assembling The Unit - Oase AquaAir Eco 250 Puesta En Marcha

Product description

Overview

 A
1 Float
2 Drum with integrated pump
3 Power connection cable
4 OASE Control OUT
5 OASE Control IN
6 Injector nozzle with Venturi principle
7 Hose for air intake
8 Knurled screw, when the knurled screw is loosened the drum can be turned to adjust the injector
nozzle
9 Fastening material contained in the scope of delivery

Installation and connection

Assembling the unit

 B
• Screw the injector nozzle onto the pump outlet.
• Attach the hose ends to the connection sockets on the injector nozzle and on the float.
– Fasten the hose with the hose clips.

Adjusting the injector nozzle

 C
• Undo the knurled screw for locking the drum.
• Turn the drum until the injector nozzle is in the desired position.
• Tighten the knurled screw.

To optimize the effect of the injector nozzle, note the specified minimum distances from
the bottom of the pond.
− When the injector nozzle is directed downwards towards to the bottom of the pond, it
generates deep aeration, thereby biologically activating the pond sludge.
− When the injector nozzle is directed at a flatter angle, it generates a stronger water flow.
14
Control system connection
The AquaAir Eco 250 is controlled via the OASE control network. For this
purpose you can connect the AquaAir Eco 250 either to the OASE Garden
Controller or to the OASE InScenio FM-Master Home/Cloud. For infor-
mation on OASE Control visit www.oase.com.