How To Use The Appliance - Fagor BV-460 Manual De Instrucciones

appliance on or near hot surfaces (gas
burners, electric hotplates or ovens).
• Do not leave the appliance unattended
while in use.
• Do not remove the jug from the motor
base while the appliance is in operation.
• This appliance has a safety switch which
blocks the mechanism if the jug is not in
place (or not properly positioned) on the
motor base.
Do not use the jug to switch the
appliance on and off.
• Do not use the mixer while empty, as this
may damage it.
- Always use the mixer with the jug lid
properly in place.
- Do not fill the jug with food at a
temperature of over 80º C.
- Do not fill the jug to more than 2/3 of its
capacity, as it may overflow.
- Handle the blade with care in order to
avoid the risk of cuts.
- Do not insert your hand or any other
object into the jug while the mixer is in
operation. If necessary, disconnect the
appliance and use a spatula to remove
any food stuck to the sides.

4. HOW TO USE THE APPLIANCE

Before using the mixer for the first time,
clean the jug (C), the measurer lid (A) and
the jug lid (B) in hot water and washing
up liquid. Dry all parts thoroughly before
replacing.
Assembly
All assembly and disassembly operations
should be carried out while the appliance is
unplugged.
Before switching it on for the first time, take
a moment to become familiar with your
mixer by assembling and disassembling it.
• Place the jug (C) on the motor base (G)
(Fig. 2)
Model BV-480
• Put the measurer lid (A) into the jug's lid
(B) by inserting its fins into the grooves
in the lid and turning in a clockwise
direction (Fig. 3)
• Add the ingredients to the jug and put
the lid on.
• To take the mixer apart, do the same as
for assembly, but in reverse order.
Model BV-460
• If you wish, insert the filter (D) by fitting
the filter's grooves into the jug's guides
(Fig. 4)
• Put the lid on as show in figure 5 and
lock it by tightening the side grippers
• Add the ingredients to the jug through
the opening in the lid.
• Put the measurer (A) into the lid (B) by
inserting its fins into the grooves in the
lid and turning in a clockwise direction
(Fig 3)
• To dismantle the mixer, do the same as
for assembly, but in reverse order
Operation
• Place the assembled mixer on a stable
surface. Make sure that the selector (H)
is in the '0' position.
• Plug the appliance into the mains.
• Chop the products to be liquidised and
place them in the jug. Next add the
liquid, making sure you do not exceed
the maximum level indicated on the jug.
• Close the jug (C) as explained in the
"Assembly" section.
• For continuous operation, turn the
selector to the '1' '2' or '3' position,
depending on the speed you would
like.
Speeds '1' and '2' are recommended for
liquids, such as milkshakes, for example.
Speeds '2' and '3', on the other hand, are
recommended for thicker foods, such as
purées.
• If you want to use the mixer for
momentary operations, turn the selector
to the "P" position, and alternate it
continuously with the '0' position.
10