Cleaning; Maintenance; Storage; Transportation - PAR PABSP 20-Li B2 Traducción Del Manual Original

˜ Cleaning
Never allow fluids to get into the product .
¾
The product must always be kept clean, dry
¾
and free from oil or grease . Remove debris
from it after each use and before storage .
Regular and proper cleaning will help ensure
¾
safe use and prolong the life of the product .
Clean the product with a dry cloth . Use a
¾
soft brush for areas that are hard to reach .
In particular clean the air vents after every
¾
use with a cloth and soft brush .
The vents must always be clear .
¾
NOTE
Do not use chemical, alkaline, abrasive
u
or other aggressive detergents or
disinfectants to clean this product as they
might be harmful to its surfaces .
˜ Maintenance
The product is maintenance-free .
¾
Before and after each use, check the product
¾
and accessories (e .g . accessory tools) for
wear and damage . If required, exchange
them for new ones as described in this
instruction manual . Observe the technical
requirements (see "Technical data") .
˜ Repair
This product does not contain any parts that can
be repaired by the user . Contact an authorised
service centre or a similarly qualified person to
have it checked and repaired .
˜ Storage
Push the rotation control switch 5 to the
¾
centre position to lock the on/off switch 6 .
Clean the product as described above .
¾
Store the product and its accessories in a
¾
dark, dry, frost-free, well-ventilated place .
Always store the product in a place that is
¾
inaccessible to children . The ideal long term
storage (longer than 3 months) temperature
is between +20 and +26 °C .
Guide the drill bit into the bit holder 8 .
¾
Store the product in its carrying case 19 .
¾
Battery pack advice
Only store the battery pack 10 partially
¾
charged . The battery pack should be
charged to 40 to 60 % (red and orange LED
in the charge indicator 14 light up) before
storing for extended periods .
Check the battery pack 10 charge about
¾
every 3 months when storing for extended
periods . Recharge as necessary .
˜ Transportation
Push the rotation control switch 5 to the
¾
centre position to lock the on/off switch 6 .
Transport the product in its carrying case 19 .
¾
Protect the product from any heavy impact
¾
or strong vibrations which may occur during
transportation in vehicles .
Secure the product to prevent it from slipping
¾
or falling over .
GB/MT 73