Uline POWER BREEZER H-8656 Manual Del Usuario página 2

4. Lift fan head and align it with the fan head support
pole. Once the fan head is seated on the support
pole, rotate fan head horizontally until it engages
with support pole. (See Figure 2)
NOTE: Once installed, the atomizer (metal disk)
will face the water tank.
5. Plug into a 110V or 220V outlet equipped with GFCI.
LED lights on the control panel will illuminate.
CAUTION! Do not plug into standard outlet
without the GFCI feature.
1. Add water to the tank.
NOTE: Do not fill the water tank above the max
fill level.
2. Route the fan head power cord, atomizer drain hose
and water inlet hose through the openings in the
back of the water tank. (See Figure 3)
Figure 3
Fan Head
Power Cord
Atomizer
Drain Hose
Control Panel
Water Inlet Hose
PAGE 2 OF 9
SETUP CONTINUED
Figure 2
OPERATION
3. Misting level can be adjusted using the water valve
located inside the tank. To increase mist, turn the
lever counterclockwise. (See Figure 4)
Figure 4
4. Slide lid into notch in back of water tank. Lower front
of lid and re-lock lid latch.
5. To fully drain the water tank, turn and open the drain
plug counterclockwise. (See Figure 5)
Figure 5
Atomizer
Water Valve
MAX FILL LINE
Fan Head
Fan Head
Support Pole
Water Tank
0721 IH-8656