2. Remove five 10 mm bolts fastened to the base using
a 10 mm socket wrench. Use same bolts to secure
the assembled pedestal to the base. Tighten with
10 mm socket wrench. (See Figure 2)
Figure 2
3. Align fan head with mounting holes on assembled
pedestal. Use 19 mm bolt, lock washer and nut to
secure through top hole. Use 11 mm bolt, washer,
lock washer and nut to secure through bottom
crescent slot. Tighten with 19 mm and 11 mm socket
wrenches. (See Figure 3)
4. Secure power cord from the motor to the bottom of
the pedestal using two zip ties. (See Figure 3)
OSCILLATING (FOR H-1407, H-1408)
Push up lever to stop fan from oscillating and pull down
to start again. (See Figure 4)
PAGE 2 OF 6
ASSEMBLY CONTINUED
10 mm
Bolt
OPERATION
1-800-295-5510
uline.com
Figure 3
19 mm
Lock Washer
19 mm
Bolt
11 mm
Bolt
11 mm
Lock Washer
11 mm
Washer
19 mm
Nut
11 mm
Nut
Zip Tie
Figure 4
Lever
1021 IH-989