Replacing The Blade Unit; Maintenance; Troubleshooting; Packaging, Storage And Transport - Martellato Mart Manual De Uso Y Mantenimiento

9.0 REPLACING THE BLADE UNIT

1) Should the blades become worn, the whole blade unit
can be replaced.
2) Switch off the appliance with the power switch and
unplug the power cord.
Remove the roll, if one has been loaded.
3) Remove the front tray temporarily by loosening the
knobs at the sides.
4) Remove the cutting unit using the relevant lever on the
bottom of the appliance.
5) Insert the new unit in the machine, being careful to slot
the front panel into the guides and pressing down gently.
You can order the blade unit from your dealer or contact
Martellato srl.

10.0 MAINTENANCE

1) Switch off the appliance with the power switch and
unplug the power cord from the machine.
2) Remove the front tray temporarily by loosening the
knobs at the sides.
3) Remove the cutting unit using the relevant lever on the
bottom of the appliance.
4) Use a mild cleaner with a swab to remove any residues
and clean the blade; do not use water or other harsh
cleaners.
5) Where necessary, insert a drop of food-grade lubricant
into the relevant three holes in the cutting unit and wipe it
down with a cloth.
6) Remove any residues of the cake band that might
prevent the optical sensors from working properly.
7) Insert the cutting unit, being careful to slot the front
panel into the guides and pressing down gently.
22
LOWER BLADE UNIT
LUBRICATION
HOLES
WATCH OUT
FOR THE BLADE
TAKE CARE AROUND
SENSORS
DPL50MC001 - ENGLISH

11.0 TROUBLESHOOTING

FAULT
The switch is set to ON but the
A)
machine does not work.
B) The blade is not moving correctly.
Strip length does not match the set
C)
length.
Error-02
D)
comes up on the display.
Error-03
E)
comes up on the display.
If issues with Mart Cutter's operation persist, only seek assistance from the dealer
or Martellato customer support centre.

12.0 PACKAGING, STORAGE AND TRANSPORT

The appliance comes packed as follows:
· Cardboard box
· Operating instructions booklet
· Protective fabric cover
· EU declaration of conformity
Storage conditions:
Store Mart Cutter in its original packaging, in a dry place at a temperature in the 5° to
40 °C range.
Keep the original packaging for possible future transport purposes.
DPL50MC001 - ENGLISH
POSSIBLE CAUSES REMEDY
Check that the power cord is
The cord has come loose.
plugged in properly or replace
The fuse has blown.
the fuse.
Check the cutting unit and push
The cutting unit is not positioned
it down, following procedure 10
correctly.
(maintenance).
Fit the roll on the relevant holder
Roll not positioned correctly. and check that there is nothing
preventing it from rotating freely.
Check the cutting unit and push
The cutting unit is not positioned
it down, following procedure 10
correctly.
(maintenance).
The band is not compatible with Use cake band with a thickness in
the machine's specifications. the 80 to 150 MY range.
Remove the band by pressing the
key.
Switch off the machine and check
Indicates that the motor is locked the cutting unit and roll; remove
out as a result of overloading. and clean any residues of the
cake band or any other material
that might prevent the machine
from working properly.
23