Taking Out Of Service / Disposal; Cleaning; Product Compliance And Marking; Declaration Of Conformity - Martellato Mart Manual De Uso Y Mantenimiento

13.0 TAKING OUT OF SERVICE / DISPOSAL

The product contains the following main kinds of material:
· Plastic
· Metals
· Electrical components
Protection made from polyester - cotton - LDPE bag
These materials must be disposed of in full compliance with
current environmental regulations.
As specified on the EU Declaration of Conformity, Mart Cutter
complies with the European RoHS directive 2011/65/EU.
Mart Cutter falls into the category of products covered by the European waste electrical
and electronic equipment (WEEE) directive 2012/19/EU and, as such, is marked with
the symbol:
It must be disposed of according to specific provisions relating
to products classed as <large household appliances> and <small
household appliances.
You should therefore seek relevant information

14.0 CLEANING

Before cleaning the appliance, follow the steps below in the
order given:
· Switch the appliance off with the ON/OFF switch;
· Unplug the unit from the 230V power socket;
Clean the lower band feeder with a damp cloth; do not use scouring pads.
How to clean the plastic outer housing:
1. use warm water applied with a damp sponge;
2. be careful not to splash accessible electrical parts with water
24
from the competent authorities.
DPL50MC001 - ENGLISH

15.0 PRODUCT COMPLIANCE AND MARKING

The nameplate illustrated above must be protected from damage for product
traceability purposes: if this requirement is not met, we will be unable to provide
technical support for the product.
Materials and items due to come into contact with foodstuffs meet the requirements
of EU and Italian regulations.

DECLARATION OF CONFORMITY

The product meets the essential requirements of the following European directives:
Low Voltage Directive (LVD): 2014/35/EU
Electromagnetic Compatibility (EMC): 2014/30/EU
RoHS II: 2011/65/EU
The following standards have also been applied:
EN 62368-1:2014
EN 55032: 2015, EN 55035:2017
EN 61000-3-2:2014, EN61000-3-3:2013
DPL50MC001 - ENGLISH
25