Publicidad
Idiomas disponibles
Idiomas disponibles
position. Afterwards, press either the
up or down button on the blind twice.
The blind will move slightly up and
down to confirm the setting.
Repeat the above steps to set a new
desired minimum height.
Correcting unbalanced blind
If the blind gets stuck when lowering, it
might become unbalanced.
Raise the blind completely to level it
again.
Adding devices to your remote
Pairing: Used to add IKEA Home
smart products to your system.
> 10 s
Follow these steps to add more wireless
blinds to your system. Make sure that
your wireless blind is turned on.
1. Open the back cover of the remote
and find the pairing button.
2. Short press both buttons on the blind.
This will wake up the device and it is
ready for pairing for 2 minutes.
3. Hold the remote close to the wireless
blind you want to add: no more than
5 cm away from (1).
4. Press and hold the pairing button on
the remote for at least 10 seconds.
5. A red LED light will illuminate on
the remote. On your wireless blind,
a white LED light will begin to dim
and flash until the devices have been
successfully paired.
Up to 10 wireless blinds can be paired
with 1 remote.
Make sure to pair one blind at a time.
If you have difficulties pairing multiple
blinds, temporarily disconnect those
that have already been paired by
disconnecting the battery pack inside
the blind. This will help with the pairing
process.
Changing the remote's battery
When the remote is used regularly and
as intended, the battery will last for
approximately 2 years.
When it's time to replace the battery,
6
Publicidad
