Lotus SmarTime 50040 Manual De Usuario página 9

This product should not be worn when show-
ering or used in a sauna/steam room as it is
not possible to prevent steam entering the
watch. Any water damage to the product due
to non-compliance to this instruction will not
be covered by the warranty.
1. Functions
introduction
1.1 Buttons
Button A: From dial, press the button to en-
ter or leave the menu. When in a function,
press the button to return to dial. Press and
hold on the button to power on / power off
the smart watch.
Button B: Press to enter sports mode.
C: touch screen
1.2 Charging Guide
Magnetic charging is as shown below. This
watch supports a PC USB or 5V charger. It takes
about 2 hours to fully charge the battery.
Be aware that the two pins of the USB
cable are not allowed to contact the conduc-
tor at the same time, or it will cause short cir-
cuit and burn.
1.3 Shortcut functions:
1) From Dial, swipe from right to left to enter
Data. Swipe to left again to enter Heart rate
measuring and again to see Sleep monitor-
ing. Swipe again to add one more function.
2) Swipe down to for shortcut settings.
3) Swipe right for notification history and last
used functions.
4) Swipe up for Menu and when in Menu,
swipe again to see whole Menu
5) Press on the Dial to enter change Dial mode.
Swipe to select and click to confirm.
1.4 Shortcut Setting menu
From Dial, swipe down to see Date, Bluetooth
connection status, Power and Time.
1) About; FW version and MAC
2) Settings
3) Brightness
4)
Stopwatch
1.5 Notifications:
Connect to the Lotus SmarTime application.
You need to give the app the permissions to
show SMS, Calls or other notification of the
mobile phone first. Then the device can display
the same notifications as on mobile phone.
1.5.1. Incoming call notification:
Enable Incoming call in the app. The watch
lights up and vibrate when there are incoming
calls.
1.5.2. Messages notification:
Enable SMS in the app. The watch displays the
message and vibrate when there is an incom-
ing message.
1.5.3. Other APP notifications:
Enable APP notifications, all or selected. The
watch displays the message and vibrate when
there is an incoming message.
1.6 Data
Health Data is activated by default. Swipe left
on the Dial interface to enter Data. Data shows
steps, distance and calories. The data will be
cleared after 12 pm every day. You save the
data by being connected to the app every day.
1.7 Sports mode
1.7.1 Select sport (Walking, Running, Cycling,
Rope skipping, Badminton, Basketball, Foot-
ball) and start by tapping that sport. Pause by
swiping right and continue by swiping back or
tap arrow. Stop the session by tapping X.
1.7.2 The work out can only be saved if it lasts
for more than 1 min. Or you will see "too lit-
tle data to save" when stopping. You save the
data by being connected to the app every day.
9 9