Installing The Battery - Carson MicroFlip MP-250 Manual

INSTALLING THE BATTERY

Slide battery door open.
USING MICROSCOPE TO VIEW OBJECTS DIRECTLY
Press the LED switch
for light.
WARNING: Do not look
directly at LED light.
USING MICROSCOPE TO VIEW SPECIMEN SLIDE
Press the LED switch
for light.
Install 1 AA alkaline battery
and replace battery door.
Base plate should be in upright
position (behind battery door.)
Please note, when base plate is
in upright position only front facing
LED will illuminate.
Flip base plate down to sit underneath
the objective lens.
Please note, when base plate is down
only downard facing LED will illuminate.
WARNING: Use only alkaline battery. Keep away from fire or
excessive heat. Inspect battery for corrosion or leakage.
Insert in direction indicated. Rechargeable battery not
recommended.
ADJUSTING ZOOM & FOCUS
Place the viewing
object directly below
the objective lens.
Adjust zooming dial Rotate focusing ring
for desired level of until the image is
magnification. clear and sharp.
Insert a prepared slide into the
slot between the objective lens
and the base plate.
2