Start-Up And Use; Switching On The Hob; Switching On The Cooking Zones; Switching Off The Cooking Zones - Ariston NRA 640 E B Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 34

Start-up and use

!
The glue applied on the gaskets leaves traces of
GB
grease on the glass. Before using the appliance, we
recommend you remove these with a special non-
abrasive cleaning product. During the first few hours
of use there may be a smell of rubber which will
disappear very quickly.

Switching on the hob

To switch the hob on, press and hold the
for approximately one second.

Switching on the cooking zones

Each cooking zone is controlled using a selector
button
and a power adjustment device
consisting of a double
• To begin operating a cooking zone, press the
corresponding control button and set the desired
power level (between 0 and 9) using the buttons
- - - - -
+ + + + +
and
.
• To set the maximum power directly, press the
button briefly.

Switching off the cooking zones

To switch off a cooking zone, select it using the
corresponding selector button
- - - - -
• Press the
button: the power of the cooking zone
will progressively decrease until it is switched off.
• Alternatively, press buttons
the power immediately returns to 0 and the cooking
zone switches off.

Heating elements

Two types of heating element may be installed,
depending on the appliance model: halogen and
radiant elements.
Halogen elements emit heat via radiation from the
halogen lamps they contain.
They have similar properties to gas burners: they are
easy to control and reach set temperatures quickly,
allowing you to see the power level instantly.
Radiant elements consist of a series of coils which
allow heat to be distributed evenly at the base of the
cookware, so that all slow-flame cooking may be
performed successfully, for example stews, sauces
or reheated dishes.
6
All manuals and user guides at all-guides.com
button
- - - - -
+ + + + +
and
button.
-
and:
-
+
and
simultaneously:

Control panel lock

The controls can be locked/unlocked only while the
!
hob is on and the hotplates are turned off.
The controls can be locked to avoid the risk of
accidentally modifying the settings (e.g. children,
cleaning operations, etc.).
To lock the controls:
-
• press and hold the
button then press the
button; the hob will emit a buzzer.
The controls lock and all the power displays
L
visualise
.
If any cooking zone is still hot, the displays will
L
H
visualise
and
in turn.
The controls must be unlocked prior to performing
any adjustments: follow the above-mentioned
procedure.
The hob will emit a buzzer, all the power displays
turn off and the controls unlock.

Switching off the hob

Press the
button to switch the appliance off.
If the control panel lock has been activated, the
controls will continue to be locked even after the hob
is switched on again. In order to switch the hob on
again, you must first remove the lock function.

Practical advice on using the appliance

To obtain the best results from your hob:
• Use pans with a thick, flat base in order to fully
utilise the cooking zone.
• Always use pans with a diameter which is large
enough to cover the hotplate fully, in order to use all
the available heat.
• Make sure that the base of the cookware is
always clean and dry, in order to fully utilise and
extend the life of both the cooking zones and the
cookware.

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Nra 640 e x

Tabla de contenido