Code Identification Feature; Sleep Timer; Troubleshooting - Philips MRU4100 Manual Del Usuario

Code Identification

Code Identification Feature

The Code Identification Feature allows you to identify
the 4 digit library code stored under your device key. For
example, if you want to find out what 4 digit code is
stored under your TV device key, follow the five steps
below:
1. Press and hold the CODE SEARCH button until the
red indicator stays on, then release the CODE
SEARCH button. The red indicator blinks, then
stays lit.
2. Press and release the CODE SEARCH button again.
The indicator light blinks off.
3. To find the first digit for the code stored, press each
numeric key from 0-9 in turn. When the indicator
light blinks off the number you pressed is the first
digit for the code you are searching for.
4. To find the second digit, repeat step 3, this time
when the indicator light blinks off this is the second
digit.
5. Repeat step 3 to find the third and fourth digits.

Sleep Timer

The SLEEP button operates the Sleep function of your
device providing it supports the Sleep function.
Alternatively, you can enable the remote to turn off
your TV after a period of 1 to 99 minutes as shown
below. This feature works even if your TV does not
have its own Sleep function.
1. Press and hold the CODE SEARCH button until the
red indicator stays on. Release the CODE SEARCH
button.
2. Press and release the SLEEP button (Note any
previously set Sleep timer is canceled at this point
and the remote returns to normal operation).
3. Press and release the numeric buttons (01-99) for
the time required. The red indicator blinks off to
indicate button press acceptance and remains off
after the second button press.
4. TV Sleep Timer now set.
5. Leave the Remote pointing towards the TV with an
unobstructed path.
To cancel the Sleep Timer, press and release the
POWER button or repeat Steps 1 and 2 above.
MRU4100-OM(MX010)_H14112A.pmd
6
6-7

Troubleshooting

Remote does not operate your TV.
• Program the remote with a new code.
• Install new batteries. (You might have to reprogram
your remote after installing new batteries.)
• Remote may not be compatible with your TV.
Remote does not operate some features of
your TV.
• Program remote with a new code.
• Remote may not be able to operate all features of
your TV or button names might be different than
your TV's original remote.
Red Indicator blinks after you program a TV
code.
• Remote did not accept the code.
• Try to program the code again or try a different
code.
For help with setup, please call: 919-573-7854.
Limited Lifetime Warranty
The manufacturer warrants that this product shall be free
from defects in material, workmanship and assembly,
under normal use, in accordance with the specifications
and warnings, for as long as you own this product. This
warranty extends only to the original purchaser of the
product, and is nontransferable. Defective products,
together with the dated proof of purchase, must be
returned to the place of purchase for repair or
replacement. THERE ARE NO OTHER EXPRESS
WARRANTIES. Incidental and consequential damages
are disclaimed where permitted by law. This warranty
gives you specific legal rights, and you may also have
other rights which vary from state to state.
Made in China. Quality Assured in USA.
Ledgewood, NJ 07852
10/12/2007, 3:47 PM
7