Summer Fun SF-130 Manual De Instalación Y Mantenimiento página 7

MONOBLOC FILTER INSTRUCTIONS
All electrical installations should comply with the following standard:
that refers "to the construction of electrical installations, both in indoor and outdoor swimming pools",
or the equivalent standard in force in each region or country.
All filtering should follow the C 15-100 installation standard that stipulates that all electrical apparatus
located at less than 3.5 m. from the pool and freely accessible, should be supplied by a very low volta-
ge of 12 V. All apparatus supplied with 220 V should be located at least 3.5 m. from the swimming pool
edge. Ask the manufacturer for permission to make any modifications in one or more elements of the
filtering system.
The electrical installation should be performed by professional staff qualified in electrical installations.
The height of the sand should not exceed 2/3 of the height of the tank.
The apparatus must not be on while the pool is being used.
Do not operate the apparatus unless it is properly primed.
NEVER touch the filter when it is operating if you are wet or have wet hands.
When handling the filter or valve, DISCONNECT the power supply.
Make sure that the ground is dry before touching the electrical equipment.
Do not install the filter where it could become wet, as it may cause electrocution.
Do not allow children or adults to lean against or sit on the apparatus.
If the supply flex of the apparatus is damaged, it should be replaced. Read the instructions carefully to
replace it. If in doubt, contact the technical service.
1 PACKAGING COMPONENTS
The filter which you have just purchased is a device which is especially planned and designed for above
ground pools. As a result of its innovative design and high level of functionality, it provides you with the dif-
ferent components required to filter water: filter, pump and selector valve in a single unit. The main compo-
nents of this filter are as follows:
C C O O M M P P O O N N E E N N T T S S
4 way valve
Filter body Ø300
Filter base
Connection hose Ø38
Pump "COMPACT 0,4"
Hose clamps
Nut Ø 2 ¼"
Discharge sleeve Ø38
O-Ring
1.1 REQUIREMENTS FOR CORRECT INSTALLATION
This filtration system is easy to install and can be assembled by ONE ADULT in less than 2 HOURS, taking
care to correctly follow the instructions detailed in this manual.
Only the following tools are required to correctly handle the filter components and to install it.
TASK
Tighten the hose flanges
Protection of collector pipe
All manuals and user guides at all-guides.com
SAFETY INSTRUCTIONS. READ CAREFULLY
NF C15-1 1 00
NF EN 60-3 3 35-2 2 -4 4 1
4 way valve
Filter body Ø380
Filter base
Connection hose Ø38
Pump "COMPACT 0,6"
Hose clamps
Nut Ø 2 1/4"
Discharge sleeve Ø38
O-Ring
TOOL
7mm Stecker screwdriver
Piece of plastic
- 7 7 -
4 way valve
Filter body Ø400
Filter base
Connection hose Ø38
Pump "SENA 3/4HP."
Hose clamps
Nut Ø 2 1/4"
Discharge sleeve Ø38
O-Ring
ALTERNATIVE TOOL
Philips screwdriver
Piece of fabric
E E N N G G L L I I S S H H
4 way valve
Filter body Ø500
Filter base
Connection hose Ø38
Pump "SENA 1HP."
Hose clamps
Nut Ø 2 1/4"
Discharge sleeve Ø38
O-Ring