Installation Instructions; Tools Needed - Impecca IWA-08KSFP Manual Del Usuario

INSTALLATION INSTRUCTIONS

Your air conditioner is designed to install in standard double hung windows with opening widths of 23 to 36 inches
(584mm to 914mm) (See Figure 1).
OFFSET
INNER
WINDOW
SILL
INTERIOR
WALL
Mounting Hardware
Top Rail Hardware
3/8" Screws
Packaging
EXTERIOR
WALL
WINDOW LAYOUT
Top Rail
Figure A
Top Rail
Lower sash must open sufficiently to allow a clear
vertical opening of the following sizes (see Table 1).
Side louvers and the rear of the AC must have clear
air space to allow enough airflow through the
condenser, for heat removal. The rear of the unit
must be outdoors, not inside a building or garage.
Output in 8000 Btu/h
Btu/h
Size 14" (356mm)
Note: Save original carton and these installation
instructions for future reference. The carton is the
best way to store the unit during winter (or when
the unit will not be used for an extended period of
time).

TOOLS NEEDED:

Phillips Screw Driver, Drill (if pilot holes are needed)
Caution: When handling unit, be careful to avoid
cuts from sharp metal edges and aluminum fins on
front and rear coils.
Note: The top rail hardware and the following Fig. A,
Fig. B, and Fig. C are not applicable to the units more
than 10000 Btu/h.
Note: Before installing unit, the top rail must be
assembled on the unit (For <10000 Btu/h models
only).
TOOLS NEEDED: Phillips Screw Driver
1: Remove the air conditioner from the carton and
place on a flat surface.
2: Remove top rail from the rear of the packaging
material as shown in Figure A.
- 7 -
TABLE 1
10000~12000
Btu/h
15-1/2" (394mm)