Installation Instructions; Preliminary Instructions - Impecca IWA-15KSFP Manual De Usuario

InsTAllATIon InsTRUCTIons:

Please read ALL instructions before installing . Two people are recommend to install this product . If a new
Please read ALL instructions before installing. Two people are recommend to install this product.
electrical outlet is required, have the outlet installed by a qualified electrician before installing unit .
If a new electrical outlet is required, have the outlet installed by a qualified electrician before
installing unit.
Window Sash Seal
Safety Lock and
3 /4 Long Hex
Head Screw
Top Angle
Foam Gasket
Washer Head
Locking screw
Frame
Assembly
(Left)
Side Retainer
Seal-bottom
Rail to Unit
Fig.1
SASH
19 MIN.
1 /2 MIN.
Storm Window Frame or
Other Obstruction
INSTALLATION INSTRUCTIONS
1 /2 Long
Screw and
Frame
Locknuts
Assembly
(Right)
Locknut
Window Support
3 /4 Long Bracket
Flat Head
Bolt
Sill Angle
Bracket
Fig.2
SASH
19 MIN.
1 /2 MIN.
1
/2 MIN.
Board
Thickness
As Required,
Along Entire
Storm Window
Stool. Fasten
Frame or Other
With Two Nails
Obstruction
Or Screws.

Preliminary Instructions

Do the following before starting to install unit.
See illustrations below.
Check dimensions of your unit to determine
model type:
Unit Height:
Unit Width:
Min. Window Opening:
Min. Window Width:
Max. Window Width:
1. Check window opening size-- the mounting
parts furnished with this air conditioner are
made to install in a wooden sill double-hung
window. The standard parts are for window
dimensions listed above. Open sash to a mini-
mum of 19 inches(483mm). See Fig.1.
2.Check condition of window-- all wood parts of
window must be in good shape and able to firmly
hold the needed screws. If not, make repairs
before installing unit.
3. Check your storm windows-- if your storm
window frame does not allow the clearance
required, correct by adding a piece of wood as
shown in FIG. 2,or by removing storm window
while room air conditioner is being installed.
4 .Check for anything that could block airflow--
check area outside of window for things such as
shrubs, trees, or awnings. Inside, be sure
furniture, drapes, or blinds will not stop proper
airflow.
5.Check the available electrical service- Power
supply must be the same as that shown on the
unit serial nameplate. Power cord is 48 inches
long. Be sure you have an outlet near.
6.Carefully unpack air conditioner- Remove all
packing material. Protect floor or carpet from
damage. Two people should be used to move
and install unit.
10
8
18 5/8 17 5/8
/
/ 5
1
26 23
8
2
/
1
1 /
19 18
2
2
/
1
31 26
2
/
1
42 40
2