EGO ABK5200 Manual Del Operador página 9

2. While wearing protective gloves, position the bagging blade
on the flange with the surface stating "THIS SIDE FACING
GRASS" facing toward outside (Fig. 5).
3. Align the washer with the motor shaft and mount it onto the
motor shaft.
4. Mount the bolt into the motor shaft. Hand-tighten the bolt
clockwise.
5. Move the blade by hand to align the two holes in the blade
with the two holes in the flange (Fig. 6).
6. Place a metal rod with diameter less than 1/4 in (6.35 mm)
(e.g., a bit) into the aligned hole in the blade and the flange to
act as a stabilizer. Place another screwdriver or metal rod with
diameter less than 5/16 in (8 mm) into the fixing hole in the
motor to act as a stabilizer (Fig. 7).
7. Use a 9/16 in (14 mm) torque wrench to tighten the bolt
clockwise. The recommended torque for the blade bolt is
36-41 ft-lb (50-55 Nm).
8. Repeat the steps with the other two blades.
9. Reassemble the deck onto the mower in the reverse order.
WARNING: Ensure that the bagging blades are properly seated
and the blade bolts are tightened to the torque specifications above.
Failure to properly attach the blades could cause them to come
loose and result in possible serious personal injury.
5
6
Aligned Holes
7
Stabilizer 1
GRASS BAGGER KIT — ABK5200
Stabilizer 2
9