Replacement Parts; Troubleshooting - Fluval SIENA 166 Manual De Instrucciones

FLUVAL SIENA LED STRIP LIGHTS SPECIFICATIONS
Aquarium Model SIENA 166
BT LED UNIT SIENA
LED STRIP LIGHT UNIT
LED STRIP LIGHT MODEL NUMBER A13253
2 x 22W
LUMINAIRE WATTAGE
LUMENS 2 x 2000 lm
24Vdc
LUMINAIRE OPERATING VOLTAGE
LED DRIVER TYPE (x 2) S024AM[X]2400100
100-240Vac
LED DRIVER INPUT VOLTAGE
X= B For UK Plug X= V For EU Plug

TROUBLESHOOTING

If an LED Strip Light does not turn on, please proceed as follows:
PROBLEM
Missing connection of the LED driver
to the power outlet.
The light isn't working.
Missing connection of the lighting unit
to the LED driver.
If the problem is not solved after following the above, please contact your Hagen retailer.
LED STRIP LIGHTS AND TANK MAINTENANCE
CLEANING THE LED STRIP LIGHTS
Disconnect the plug of all the electrical equipment from power supply before any maintenance operation.
WARNING: Be sure you unplug the LED drivers from the power outlet; just switching off the lights with the APP is NOT enough because it does not stop the power supply.
Never place the LED Strip Lights under water jets or submerge in water.
For maximum LED performance, it is recommended that the fixtures and LED lens be cleaned on a weekly basis. Unplug the LED drivers prior to cleaning the light fixtures. Use
both hands when manipulating these appliances. Wipe exposed surfaces carefully with a damp cloth to remove any dust or mineral deposits that may collect over time. Do not
use detergents or harsh cleaners as it can damage the light fixtures.
Use Fluval LED Lens Cleaning Kit (A3969) to clean the LED portion of the light fixtures. Make sure all surfaces are dry before re-connecting the LED drivers to the power source.
No special maintenance is required for the Fluval LED Strip Lights and covers, other than periodic cleaning with a damp cloth (never use harsh chemical products or detergents).
To remove calcareous deposits, it is recommended to use a mild acid such as lemon juice, followed by a thorough wipe down with a damp cloth to remove any residue.
SALTWATER AQUARIUMS
It is commonly known that saltwater is far more corrosive, conductive (of electricity) and generally degrades both plastic and metal parts at an accelerated rate versus fresh
water. To minimize salt accumulations on the Fluval Covers and on the LED Strip Lights, it is recommended to take note of the following helpful tips:
1. Make sure filter outputs do not spray above the water surface; position them below the water surface with a slight downward angle,
but still allow for surface movement (contributes to oxygenation).
2. If an air pump must be used, frequent removal of salt deposits will be necessary.
3. Keep the water level as constant as possible (regular top-ups due to evaporation). This is beneficial in providing stable salinity and will help protect the cover.
4. It is recommended to regularly clean all LED Strip Light components that come into contact with saltwater on a weekly basis. The cleaning should be carried out with
a wet cloth (never use harsh chemical products or detergents). Simple lemon juice may be used to take away salt accumulation. Afterwards, rinse carefully to eliminate
every residue of acid.
10
09611500 SIENA 15L.indd 10-11 09611500 SIENA 15L.indd 10-11
SIENA 272 SIENA 332
BT LED UNIT SIENA BT LED UNIT SIENA
A13254 A13255
2 x 36W 2 x 48W
2 x 3300 lm 2 x 4400 lm
24Vdc 24Vdc
S040Q[X]2400150 S050F[X]2400200
100-240Vac 100-240Vac
X= U For US Plug X= S For AUS Plug
CAUSE SOLUTION
Connect the LED driver to the power outlet.
Connect the lighting unit to the LED driver
with its connector.

REPLACEMENT PARTS

Always use genuine Fluval Spare Parts to guarantee continued performance and safety.
For a full listing of replacement parts, please visit www.fluvalaquatics.com
Fluval Siena 166
2 x Top Sliding Covers A13313
1 x LED Strip Light A13253
1 x LED Driver A20432
1 x Over-rim Cable Guide A13866
1 x Top Cover Grid A13316
4 x Electrical Cable Hooks A13867
RECYCLING
This product bears the selective sorting symbol for waste electrical and electronic equipment (WEEE). This means that this
product must be handled pursuant to European Directive 2012/19/EU in order to be recycled or dismantled to minimize its
impact on the environment. For further information, please contact your local or regional Authorities.
Electronic products not included in the selective sorting process are potentially dangerous for the environment and human
health due to the presence of hazardous substances.
2 - YEAR LIMITED WARRANTY
Your Fluval Aquarium and LED Strip Lights are guaranteed for defective parts and workmanship for a period of two years from the
date of purchase. This guarantee is valid with proof of purchase only. The guarantee is limited to repair or replacement only and does
not cover consequential loss, loss or damage to livestock and personal property or damage to animate or inanimate objects,
irrespective of the cause thereof.
This guarantee is valid provided the aquarium is placed in a suitable location that is flat and level and has been installed in accordance
with the installation instructions and care guide. This guarantee excludes aquarium breakage due to misuse, chips, stress cracks caused
by improper support or other breakage. This guarantee is valid only under normal operating conditions for which the unit is intended.
It excludes any damage caused by unreasonable use, negligence, improper installation, tampering, abuse or commercial use.
The warranty does not cover wear and tear, breakage of glass or parts which have not been adequately or correctly maintained.
If at some time in the future you have cause to claim under this guarantee, you will need to provide proof and date of purchase.
We recommend that you retain your receipt for this purpose. Rolf C. Hagen Inc. wishes you many hours of enjoyment with your
Fluval aquarium.
FOR AUTHORISED GUARANTEE REPAIR SERVICE
For Authorised Guarantee Service, please return (well packaged and by registered post) to the address listed on the last page enclosing dated receipt and reason for return.
If you have any queries or comments about the operation of this product, please let us try to help you before you return the product to your retailer.
Most queries can be handled promptly with a phone call.
When you call (or write), please have all relevant information such as model number, age of product, details of aquarium setup, as well as the nature of the problem.
If you have any queries or comments about the operation of this product, please contact your Specialist Aquatic Retailer in the first instance.
Most queries can be handled easily at store level. In the unlikely event that it cannot, please return the item to the retailer, with your valid proof
of purchase, for repair or replacement under the two-year warranty terms.
Fluval Siena 272 Fluval Siena 332
A13314 A13315
A13254 A13255
A20433 A20435
A13866 A13866
A13316 A13316
A13867 A13867
11
29/07/21 11:45 29/07/21 11:45