Intended Use; Specifications Supplied; Description Of Parts - LIVARNO home 1002-W Instrucciones De Uso Y De Seguridad

Motion sensor field of view
Motion sensor detection range
Illumination time
Beam width
Any protective cover that is
cracked or split must be
replaced� If the outdoor
spotlight is damaged in any
way, stop using it immediately
and contact the service address
indicated below�
Protection class I: the user and
third parties are protected
against electric shock by a
protective earth (PE) conductor�
With the CE label, the
manufacturer confirms that this
electrical device complies with
the applicable European
directives�
Packaging made of FSC-
certified wood mix
MIX
Packaging
The "GS" symbol stands for
safety-tested� Products that are
marked with this symbol meet
the requirements of the
German Product Safety Act
(Produktsicherheitsgesetz)�
z Intended use
This product is classed as a special product
because it can be operated at temperatures
below -21°C and remain fully functional� The
outdoor spotlight is intended for permanent
installation in a place protected from rain
and is intended exclusively for use as
temporary outdoor lighting, e�g� for
32
GB/MT
illuminating private passageways, garages
or footpaths and for deterring unauthorised
intruders� The outdoor spotlight is intended
solely for use in private households and is
not suitable for commercial use� You should
only use the outdoor spotlight as described
in these instructions for use� Any other use is
considered use other than intended and may
cause property damage or personal injury�
The outdoor spotlight is not a toy� The
manufacturer or retailer accepts no liability
for loss or damage that occurs as a result of
use other than intended or incorrect use�
z Specifications supplied
1 LED outdoor spotlight with motion sensor
1 wall bracket (for mounting on building
walls or corners) inc. fixings (4 wall plugs,
2 screws (10mm), 4 screws (25mm))
1 instruction manual
z Description of parts
LED module
1
Motion and twilight sensor
2
LUX control
3
(for setting sensitivity of twilight sensor)
TIME control
4
(for setting the illumination time)
SENS control
5
(for setting the detection range)
Terminal strip
6
Strain relief clamp
7
Household mains live conductor L
8
Household mains protective earth
9
conductor PE (green/yellow)
Household mains neutral conductor N
10
Gland nut
11
Cover plate
12
Always On/Automatic mode switch
13
Screw (cover plate)
14
Cable grommet
15